Amantii TRD-33 Traditional 33 Electric Fireplace User Guide
- June 12, 2024
- Amantii
Table of Contents
Amantii TRD-33 Traditional 33 Electric Fireplace
Replace LED light
For ember bed
Step 1 Unscrew 2 screws from the trim where marked red arrows.
Step 2 When the screws are removed, you can take off the trim. Please mind there are magnetic stones fixed at the bottom of the trim connecting the trim and the fireplace
Step 3 When the trim is removed, you can take off the front glass panel.
Step 4 Unscrew the 2 screws on each side to take off the inner side metal piece fixing the ember bed glass panel.
Step 5
After the inner side metal pieces are removed, you can take off the ember bed
glass panel now.
Step 6 Now you can replace LED light for ember. Unplug to replace it.
LED light for the flame
Step 7 Unscrew the screws to take off the metal bar fixing the back glass panel.
Step 8 After metal bar is removed, now you can take off the back glass.
Step 9 Unscrew the screws to take off the flame stencil.
Step 10 When the flame stencil is removed, you can see the LED light for the flame under it. Now you can replace the LED light for the flame.
Replace flicker motor for the flame
Please follow Step 1 to 9 in replacing LED light.
Step 1
Unscrew the screw and then disconnect the flicker rod from the motor
Step 2
Unscrew the screws to take off the motor from the fireplace
Replace PCB Board
Please follow Step 1 to 3 in replacing LED light.
Step 1 Unscrew the screws on 4 sides to take off the top cover.
Step 2 After the screws are removed, you can take off the top cover now.
Step 3 Unscrew the screws to replace the PCB board.
Replace heating assembly
Please follow Step 1 to 8 in replacing LED light.
Step 1 Unscrew the screws to disconnect the heating assembly from the fireplace.
Step 2 Now you can take off the heating assembly from the fireplace. Unscrew the screws to take off the metal pieces from the heating assembly. Unplug to replace the heating assembly.
Replace the touch panel
Please follow Step 1 to 3 in replacing LED light.
Step 1 Unscrew the screws on 4 sides to take off the top cover.
Step 2 Unscrew the screws take off the fireplace.
Step 3 Unplug to replace the touch panel.
Replace the canopy light
Please follow Step 1 to 8 in replacing LED light.
Step 1 Unscrew the screws to disconnect the canopy light from the fireplace.
Step 2 Pull the canopy light out under the heating assembly
Step 3 Unplug to replace the canopy light
Replace the signal receiver
Please follow Step 1 to 8 in replacing LED light.
Step 2 Unscrew the screws
Step 3 Plug to replace the signal receiver
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>