VEVOR ZPETQQMC000000001V0 Hanging Tree Tent Instructions

June 12, 2024
VEVOR

VEVOR-LOGO

VEVOR ZPETQQMC000000001V0 Hanging Tree Tent

VEVOR-ZPETQQMC000000001V0-Hanging-Tree-Tent-PRO

Product Information

This product requires adult assembly and supervision. It should be unpacked and assembled by an adult, including site and tree selection. The product contains potentially hazardous small objects when in an unassembled state, therefore it is important to keep it out of children’s reach.

WARNING: Adult assembly and supervision are required. This product should be unpacked and assembled by an adult, including site and tree selection. In an unassembled state, it contains potentially hazardous small objects, please keep out of children’s reach.

Product Usage Instructions

  1. Unpack the product and ensure all parts are present.
  2. Select a suitable location for the product, ensuring it is away from any hazards such as power lines or other obstructions.
  3. Select a tree that is strong enough to support the weight of the product and ensure it is at least 12 inches in diameter at the point of attachment.
  4. Assemble the product according to the instructions provided by the manufacturer.
  5. Once assembled, attach the product securely to the selected tree using the appropriate hardware provided.
  6. Inspect the product regularly for any signs of wear or damage and make any necessary repairs or replacements before use.
  7. Always supervise children when using the product and ensure they follow all safety guidelines outlined in the user manual.

Following these instructions will ensure the safe and proper usage of the product. If you have any questions or concerns, please refer to the user manual or contact the manufacturer for assistance.

USER WARNINGS

  • Before use, make sure the swing is in good condition and that the hardware/hanging points are secure.
  • Do not use swing if equipment is wet.
  • Do not swing beyond a 45° angle.
  • Do not place anything underneath the swing that could hinder or obstruct the swinging motion.
  • Do not attach items to the swing (jump ropes, clotheslines, cables, chains, etc.) as this could be strangulation hazard.
  • User must dress appropriately to use swing. Do not wear loose clothing or clothing with cords and drawstrings.
  • Remove shoes when using swing.
  • Do not jump on the swing or jump into the swing. Step onto the swing carefully.
  • Do not jump off the swing.
  • Do not walk or stand in the proximity of a moving swing.
  • Do not push an empty swing as it may hit a person and cause injury.
  • Only sit in the swing; do not stand.
  • During use, stay in the center of the swing.
  • Maintain control of the swing at all times.
  • Do not use if any part of the swing is broken or loose.

NOTICE: Please retain these instructions for future reference.

  • Adult assembly and installation is required.
  • This swing is for household, indoor/outdoor use only.
  • Only use with adult supervision. Do not allow children to play alone.
  • A maximum of two children are allowed on the swing at a time.
  • Do not stand on or use any part of this item as a step ladder.
  • Firmly secure all bolts, screws and knobs before use.
  • Reconfirm that all bolts, screws, and knobs are secure every 90 days.
  • This item is not intended for use by persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the item by a person responsible for their safety.
  • If any parts are missing, broken, damaged, or worn, stop using this product until repairs are made and/or factory replacement parts are installed.
  • Do not use this item in a way inconsistent with the manufacturer’s instructions as this could void the product warranty.
    AGE RANGE: 3 years old and up

TOOLS REQUIRED

VEVOR-ZPETQQMC000000001V0-Hanging-Tree-Tent- \(2\)

HARDWARE

VEVOR-ZPETQQMC000000001V0-Hanging-Tree-Tent- \(3\)

PARTS

VEVOR-ZPETQQMC000000001V0-Hanging-Tree-Tent- \(4\)

PRODUCT ASSEMBLY

  1. Slide three part B top frames into the designated sleeves inside the part A tent. Attach the top fram s to one another.VEVOR-ZPETQQMC000000001V0-Hanging-Tree-Tent- \(5\)
  2. Attach four part C bottom frames. Secure the bottom frame to the bottom of the tent with the attached adhesive strips.
  3. Place the cushion D in the zippered compartment at the bottom of the tent.VEVOR-ZPETQQMC000000001V0-Hanging-Tree-Tent- \(6\)
  4. Install 3 AA batteries in the part E string lights. Place the battery box in the pocket, then route the string lights through the loops on the top of the tent. Use switch to cycle between OFF, ON, and FLASHING.VEVOR-ZPETQQMC000000001V0-Hanging-Tree-Tent- \(7\)

MOUNTING SWING

  1. Line up the part 2 mount and use a pencil to mark the desired mounting location.VEVOR-ZPETQQMC000000001V0-Hanging-Tree-Tent- \(8\)

  2. Drill four holes at the mounting location.
    NOTE: Drill approximately a ¼” deeper than the length of the sleeve anchor.VEVOR-ZPETQQMC000000001V0-Hanging-Tree-Tent-
\(9\)

  3. Insert four part 1 sleeve anchors into the holes. Use a hammer it necessary. Remove the nuts/washers from the sleeve anchors.VEVOR-ZPETQQMC000000001V0-Hanging-Tree-Tent- \(10\)

  4. Place the mount, then tighten the nuts to secure the mount.VEVOR-ZPETQQMC000000001V0-Hanging-Tree-Tent- \(11\)

  5. Use the part 4 carabiners and part 3 rope to hang the tent swing from the mount.VEVOR-ZPETQQMC000000001V0-Hanging-Tree-Tent- \(12\)
    NOTE: The swing can also be installed on a stand, tree branch, beam, etc.

INSTALLATION TIPS

  • Make sure overhead structure can support a minimum of 220 lbs. If hanging from a tree, diameter of tree limb should be 10 inches.
  • Have adults test the overhead structure by pulling down or sitting in the swing.
  • Do not install over concrete, asphalt, or hard ground.
  • Swing should have a fall zone surrounding of the swing.
    • Fall zone should extend a minimum of 18 inches on each side and twice the swing height on the front/back.
  • Place soft padding around the swing if ground is too hard.
  • Do not use in a place with excessive sunlight. In warm weather, make sure that the tent swing surface is not too hot.
  • Swing height should be 12 to 18 inches above the ground.
  • Swing must have at least 6.5 feet of overhead and side clearance from any structure or obstruction such as a fence, garage, house, branches, wires, etc.
  • Install in an area clear of wires, walls, structures, furniture, etc.

CARE AND MAINTENANCE

  • Reconfirm that all nuts, bolts, and screws are tight and secure.
  • Grease hardware and hanging points regularly.
  • Check hardware and hanging points for rust which could affect their strength. Replace if necessary.
  • Check seat, air cushion, and tent for excessive wear and tear.
  • Check ropes for fraying, wear, or breakage. Replace if necessary.
  • Do not leave the tent swing outdoors for an extended period of time.
  • In winter season, it is recommended that the tent swing is stored indoors.
  • To clean, wipe down with a damp cloth.
  • Store in a dry place away from direct sunlight.
  • Cover or store in a bag if unused for an extended period of time.

WARNING: Manufacturer and seller expressly disclaim any and all liability for personal injury, property damage or loss, whether direct, indirect, or incidental, resulting from the incorrect attachment, improper use, inadequate maintenance, or neglect of this product.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals