BaByliss D665E-S266a Salon Air Brilliance Instructions
- June 4, 2024
- BaByliss
Table of Contents
BaByliss D665E-S266a Salon Air Brilliance
Read the safety instructions first.
HOW TO USE
- Towel dry and detangle hair.
- Plug the appliance into a suitable mains socket.
- Select the required heat and speed settings.
- After use, switch off and unplug the appliance.
- Allow the appliance to cool before storing away.
IMPORTANT! Always keep the rear of the appliance away from the hair during use, to prevent it being drawn in through the rear air filter.
Heat Settings
There are 3 heat and 2 speed settings plus a lockable cold shot button. Use
the higher heat and speed settings for initial drying and use the lower heat
and speed settings
for styling and scrunch drying as the hair begins to dry.
Lockable Cold Shot
Use the lockable cold shot on warm hair to rapidly cool the hair and set the
style in place for a long-lasting effect. When in use the cold button will
illuminate.
IMPORTANT! Always ensure the lockable cold shot is in the off position when using the heat settings. If the cold shot button is activated when using the heat settings to dry the hair, it will over-ride the heat setting resulting in a cold airflow.
Concentrator Nozzle
Use the concentrator nozzle to direct the airflow as you style.
IMPORTANT ! ! Only use the concentrator nozzle on the lowest heat/speed setting.
Diffuser
Use the diffuser to enhance natural curls and create volume.
IMPORTANT! Only use the diffuser on the lowest heat/speed settings.
CLEANING & MAINTENANCE
To keep your appliance in the best possible condition, please follow the steps
below:
General
- Ensure the appliance is switched off, unplugged and cool. To clean the outside of the appliance, wipe with a damp cloth. Make sure that no water enters the appliance and it is completely dry before use.
- Do not wrap the lead around the appliance, instead coil the lead loosely by the side of the appliance.
- Do not use the appliance at a stretch from the PowerPoint.
- Always unplug after use.
Cleaning the Filter
- Ensure the appliance is switched off, unplugged and cool.
- Holding the handle of the appliance firmly, twist the rear filter to the left to remove it.
- Using a soft brush, clean any hair and other debris from the filter.
- Replace the rear filter by aligning the grooves and turning to the right until the filter clicks back into place
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>