CONSORT QSC3 Softstart Receiver Unit User Guide
- June 4, 2024
- Consort
Table of Contents
QSC3
Softstart Receiver Unit for
SL Wireless Controls
Installation and User Guide
Please read this guide carefully and retain it for future use and maintenance.
Getting to know QSC3
240V / 50Hz MAINS INPUT|
---|---
240V, 13A MAX OUTPUT
Introduction
The QSC3 was designed to control quartz heaters, however, it is capable of controlling any heaters up to a maximum load of 13A/3000W. The microcontroller-based unit incorporates zero-crossing switching and a soft- start function to eliminate the quartz heaters’ initial high inrush current – potentially in- creasing lamp life by as much as 30% and reducing the stress on the mains supply.
Installation
Care should be taken when installing the QSC3. The maximum cable the QSC3 can
accept is 2.5mm2. When refitting the lid ensure to align the light pipe on the
lid with the indicator light.
The QSC3 should be wired to a 13A fuse and must not be covered to avoid
overheating. The controlled load should be connected to the Load connection.
If being used to control heating It should not be mounted directly above or
behind the heater, ideally, it should be mounted at the side of and 250mm from
the heater.
See Fig.2 for mounting instructions.
Operation
The unit can be used as a wireless receiver, or solely as a soft start. This
needs to be selected using the small jumper switch located by the LED. It will
arrive factory set in the “Receiver-ON” position as shown in the picture. In
this mode, the LED indicator light will light up green showing power is
available to the unit. When the output has been enabled by a wireless
controller, the LED indicator light will turn red.
To disable the wireless receiver and use it solely as a soft start, remove the
jumper link and place it on the “Receiver-OFF” and middle pin. In this mode,
the light will go green momentarily then go to red enabling the output.
QSC3 can be controlled by any of the Consort wireless controllers. For
Information on pairing the controller to the QSC3, please refer to the
controller’s user instructions. The
information can be found under the “Pairing” Section.
Customer Helpline
Should you need any advice on the use of your new Consort product please
contact our Helpline:
Tel: 01646 692172
Fax: 01646 695195
Email: technical@consortepl.com
The QSC3 is guaranteed for one year against faulty material or workmanship. This applies only if the appliance has been used for purposes in accordance with the instructions provided and has not been misused, neglected, damaged, modified, or repaired by any person not authorized by us. This guarantee is offered to you as an extra benefit and does not affect your legal rights.
C onsort Equipment Products Ltd.
Registered Office: Thornton Industrial Estate, Milford Haven,
Pembrokeshire, SA73 2RT
Tel: 01646 692172
Fax: 01646 695195
sales@consortepl.com
technical@consortepl.com
BS EN ISO 9001 Registered Company No FM12671
Reasonable care has been taken to ensure that this guide is accurate at the
time of printing. In the interest of progress, the company reserve the right
to vary specifications from time to time without notice.
57000830 Iss 01
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>