SOGEDIS BGN32FRI4 Frionor Refrigerator User Manual
- June 3, 2024
- SOGEDIS
Table of Contents
BGN32FRI4 Frionor Refrigerator
User Manual
BUILT-IN 2750-2760
INFORMATION
Thermostat Setting
It ensures that the temperature settings in the cooling and freezing
compartments of your refrigerator are performed automatically. It may be set
to any value ranging from 1 to 5. As you turn the thermostat setting knob from
1 to 5, the temperature decreases. To save energy in winter months, operate
your refrigerator in a lower position.
Fridge compartment thermostat knob;
1 – 2: For short-term storage of food in the freezer compartment.
3 – 4: For long-term storage of food in the freezer compartment.
5: For freezing fresh food. The appliance will work longer. Once the food is
fully frozen, reset the thermostat to its original position. 
Warnings about Temperature Adjustments
- It is not recommended that you operate your fridge in environments colder than 10 oC in terms of its efficiency.
- Temperature adjustments should be made according to the frequency of door openings and the quantity of food kept inside the fridge-freezer.
- Your fridge-freezer should be operated for up to 24 hours according to the ambient temperature without interruption after being plugged in to be completely cooled. Do not open the doors of your fridge-freezer frequently and do not place much food inside it during this period.
- During a power cut, to prevent any compressor problem you should unplug the fridge freezer. You should delay plugging in 5 –10 minutes after your power supply returns. 0f you plug out the fridge freezer for a reason you should wait at least 5 min to replug it. It is important for avoiding damage to the fridge-freezer’s components.
- Your fridge-freezer is designed to operate in the ambient temperature intervals according to the climate class stated on the information label. In terms of cooling effectiveness, we do not recommend operating your fridge-freezer outside of the stated temperature values.
- This equipment is designed for use at an ambient temperature within the 16°C – 38°C range.
| Climate class | Ambient temperature it |
|---|---|
| T | Between 16 – 43 °C |
| ST | Between 16 – 38 °C |
| N | Between 16 – 32 °C |
| SN | Between 10 – 32 °C |
REFRIGERANT CYCLE DIAGRAM
ASSEMBLE & DISASSEMBLE
Changing The Door Swing Direction to Right Hand
-
Unscrew the two screws fixing the top hinge (Pic-1) and remove the refrigerator door. (Pic-2)
-
Unscrew the two screws fixing the middle hinge side bracket and remove it. (Pic-3)
-
Unscrew the two screws fixing the middle hinge (Pic-4) and remove the freezer door. (Pic-5)
-
Remove the bottom hinge pin (Pic-5) and insert it into the left side foot. (Pic-6)
-
Unscrew the middle hinge side bracket on the left and remove it. (Pic-7) Remove the middle hinge screw caps (big) on the left side.
-
Assemble the refrigerator door. Rotate the middle hinge by 180º and screw it to the left side. (Pic-8) Then screw the middle hinge side bracket on the middle hinge. (Pic-9)
-
Remove the top hinge screw caps (big) on the left side (Pic-10) and insert them to the right side. (Pic-11) (You can find the new caps in the user manual bag)
-
Unscrew the pin of the hinge from Hole 1, rotate the top hinge by 180º, and screw the pin to Hole 2. (Pic-12) -
Assemble the freezer door and screw the top hinge to the left side. (Pic-13)
-
Screw the middle hinge side bracket on the right of refrigerator. (Pic-14) and insert the middle hinge screw caps (big) on the right side. (Pic-15) (You can find the new caps in the user manual bag)
Replacement of Door Switch
-
Insert a screwdriver into the gap and pull the door switch.
-
Disconnect the connectors. And remove the door switch.
Replacement of Door Gasket
Pull the gasket towards starting from the top right corner
Slowly pull the rest of the gasket.
Completely remove the gasket from the door.
Check the replacement gasket form
Starting with upper right corner, press on the gasket until it fits to its
place..
Place the other sides of the gasket with the help of your thumb
After the replacement check if there are any non-fitting points on the gasket.
Also, check if there is any opening at the gasket while the door is closed. If
so that might cause condensation/icing or insufficient cooling/freezing. To
prevent this soften the form of the gasket with the help of a hair dryer or
hot water and make sure that all points are closing perfectly.
Barcode and Serial Number Explanation:
Vestel refrigerator serial numbers are consist of 22 digits.
Information About The New Generation Cooling Technology
The New Generation Cooling Technology refrigerators are different from the
other static refrigerators in terms of their operating system.
In normal fridge freezers, the humidity entering the fridge freezer due to
opening the door and the humidity inherent in the food causes freezing in the
freezer compartment. To
defrost the frost and ice in the freezer compartment, you are periodically
required to turn off the fridge, place the food that needs to be kept frozen
in a separately cooled container and remove the ice gathered in the freezer
compartment.
The
situation is completely different in no-frost refrigerators. Dry and cold air
is blown into the fridge and freezer compartments homogeneously and evenly
from several points via a blower fan. Cold air dispersed homogeneously and
evenly between the shelves cools all of your food equally and uniformly, thus
preventing humidity and freezing. Therefore your New Generation Cooling
Technology fridge freezer allows you the ease of use, in addition to its huge
capacity and stylish appearance.
TROUBLE-SHOOTING CHART
*()
Correct the gasket form by the help of hot water and hair dryer.**
Documents / Resources
|
SOGEDIS BGN32FRI4 Frionor
Refrigerator
[pdf] User Manual
BGN32FRI4 Frionor Refrigerator, BGN32FRI4, Frionor Refrigerator, Refrigerator
---|---