Badger Meter E-Series Ultrasonic Meters Programming Software User Manual

: June 4, 2024
: Badger Meter

Table of Contents

Badger Meter E-Series Ultrasonic Meters Programming Software
DESCRIPTION
Parts List
INSTALLING THE SOFTWARE
USING THE PROGRAMMING SOFTWARE
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Badger Meter E-Series Ultrasonic Meters Programming Software

DESCRIPTION

The E-Series Ultrasonic Application has the ability to modify the 35-day alarm settings on E-Series Ultrasonic meters programmed to either RTR or ADE protocol.

The software runs on a laptop and uses an IR programming head to modify the status of the following alarms to allow reads to be sent:

Exceeding Maximum Flow
Low Temperature

The following sections explain how to quickly install and start using the software application.

Parts List

Included in the kit:

Application software CD (68027-001)
Programming manual
Additional parts required:
Customer-supplied IR communication cable 64436-023
USB to Serial adapter 64436-029

INSTALLING THE SOFTWARE

This section describes how to install the E-Series Ultrasonic Programmer software.

1. Insert the CD-ROM containing the software and double-click the setup.exe file. The Welcome screen displays. Click Next.
Accept the terms to the license agreement and click Next.
At the Customer Information screen, fill in the fields and click Next.
Click Install to begin installing the software.
The InstallShield Wizard displays the installation status.
6. When the installation is complete, select Finish to exit the Wizard.

USING THE PROGRAMMING SOFTWARE

Connect the IR reader to the computer.
Double-click the E-Series Ultrasonic Programmer desktop icon.
The first time you launch the program, the License Agreement displays. Read the agreement and click Accept License. If you select Decline License, the program will not start.
Enter a three-character User ID in the box and click OK. Any three characters will open this application.
Select the COM port to which the IR reader is connected.
Position the IR reader over the E-Series IR head and click Modify 35 Day Meter Alarms.
Continue holding the IR reader in place while the meter alarms are modified.
If the alarms were successfully modified, the following screen displays.
If the alarms were not successfully modified, the following displays.
Realign the IR head and click Retry.If the retry fails, this message displays.
Make sure you have correctly installed the IR reader and selected the COM port to which it is connected.
NOTE: Alarm modification does not work in high resolution meters. If you try alarm modification on a high resolution meter, you will see this message.

Making Water Visible®
ADE, E-Series, Making Water Visible and RTR are registered trademarks of Badger Meter, Inc. Other trademarks appearing in this document are the property of their respective entities. Due to continuous research, product improvements and enhancements, Badger Meter reserves the right to change product or system specifications without notice, except to the extent an outstanding contractual obligation exists. © 2014 Badger Meter, Inc. All rights reserved.
www.badgermeter.com