mr Induction SR-65AC SMARTSCAN 2600W Countertop Commercial Range Instruction Manual

• LED displays a one or two-digit number, indicating the power level (1-20)

• The unit will continuously cook until manually shut off.
  In Function (TEMP indicator is on):

• LED displays a two or three-digit number, indicating cooking temperature.
  (90°F/32°C, 110°F/43°C, 130°F/54°C, 150°F/65°C, 170°F/76°C,
  180°F/82°C, 200°F/93°C, 220°F/104°C, 240°F/115°C, 260°F/126°C, 270°F/132°C, 290°F/143°C,
  310°F/154°C, 330°F/165°C, 350°F/176°C, 360°F/182°C, 380°F/193°C,
  400°F/204°C, 420°F/215°C, 440°F/226°C)

• The unit will cook until the set temperature is reached and will keep warm.

• When a set temperature is reached, the unit will stop heating. The unit starts heating again when it senses the temperature has dropped below seng.

• Temperature difference: when cooking a large pot of soup or other contents, please be advised that the temperature inside the pot will vary from point to point. For example, the boom section (closest to the cooktop) will be a bit hoer than the middle section. The type and quality of cookware can affect temperature transfer.

HOW TO USE

1. Plug in the power cord( refer to Specificaon on Page 10 for correct power input), unit will beep once.

2. Please use suitable cookware and add food contents.

3. Press ON/OFF buon (red indicator light will illuminate, COOK mode by default).

4. Press COOK/TEMP buon to select seng
   l COOK mode: LED displays power level: 1~20
   l TEMP mode: LED displays temperature: 90~440°F/32~226°C

5. Turn knob clockwise/counter-clockwise to set the power level or temperature.

6. When cooking is done, turn unit off by pressing ON/OFF buon.

NOTE:

• Safety feature: if no cookware is placed, the unit will shut off aer 2 minutes.
• To avoid temperature jumps, please cook at least 1 quart of food/content.
• Actual temperature (in TEMP mode) may vary slightly due to different variables, such as surrounding temperature, food content and volume, and if using a lid, etc.
• When using cookware that is not flat or with an uneven boom, the set temperature will be VERY different from the actual temperature.

**KEY POINTS BEFORE USING THE COOKTOP

**

Before Use:

Place cooktop on flat surface,but keep away from the wall or other articles. for best results,leave at least 4 inches from all sides. When the air inlet or the air outlet is blocked, the internal temperature of the cooktop rises and may automatically shut off during cooking.

Keep away from gas range or coal oil stove. If the surrounding temperature is high, the cooktop will stop heating.

Keep away from water source;the cooktop will not work if the air inlet and the air outlet are wet.

Please do not use this cooktop near the credit card, disc, watch, or radio.
During Use:

Do not place a sealed can on the cooktop. It may explode.

If the cooking oil is not enough or an empty pan is on the cooktop for too long, it will damage the cookware.

Do not place paper or cloth in between the cooktop and cookware to prevent heating.

Do not put heated oil in the pan while cooking.
Do not place one cooktop on top of another while plugged into a power source.

• Please plug this cooktop in the correct 20-amp outlet.
• Do not share the outlet with other appliances and make sure it is correctly plugged in.
• Do not touch the ceramic plate immediately after cooking, the plate may remain hot due to heat transferred from the cookware.
• Do not insert any object in the inlet or outlet to prevent electric shock.
• Do not damage the ceramic plate.
• If the ceramic plate is broken, please turn the unit off and unplug it from the outlet immediately.

IMPORTANT:

• If the electric cord is damaged, please contact our service technician for a replacement.
• This appliance is equipped with overheating protection feature.
• Those with a pacemaker should consult the physician before using this item.
• If the cooktop surface is broken or cracked, do not use the product as it may cause electric shock.

EMERGENCY PROCEDURES
If the cooktop is not working properly, please contact our service technician for assistance. Do not disassemble the unit by yourself.
LIST OF SUITABLE / UNSUITABLE COOKWARE

|
---|---

Maintaining the product

• Unplug the cord before any cleaning is done.
• To clean the ceramic plate, use a sponge with dish detergent. Then wipe clean with a damp towel.
• Clean fan intake with vacuum whenever necessary.

DO NOT IMMERSE THE COOKTOP IN WATER TO SOAK. THIS WILL DAMAGE THE COOKTOP.
NOTE
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harm to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet that’s on a different circuit than the receiver.
• Consult the dealer or an experienced radio/TV technician for help.
• Changes or modificaons not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

TROUBLESHOOTING

If LED displays any of the following error codes, unit needs to be sent in for service: EC,E0,E1,E2,E3,E4,E7,E8,E9.

cooker? Or is it an induction-compatible pan?
Low Voltage Protection| EO| Check if the voltage is low
High Voltage Protection| El| Check if the voltage is high
IGBT Overheat| E3| Circuit board inner fan was broken or the air inlet is blocked.
Coil Sensor Open Circuit or Short Circuit| E5| Check if the coil temperature sensor cable was broken, or if the plug is unplugged.
IGBT Sensor OpenCircuit or Short Circuit| E7| Check if the IGBT sensor or relevant circuit was broken
Circuit failure| EC| Check the circuit board if the components are damaged.

SPECIFICATIONS

Model| SR-65AC| SR-18AC/ SR-18BC/ SR-18CC| SR-34AC/ SR-34BC/ SR-34CC| SR- 34AWC/ SR-34BWC
---|---|---|---|---
Voltage| 220-240V —60Hz| 110-120V “60Hz| 220-240V —60Hz| 220-240V —60Hz
Consumption| 2600W| 1800W| 3400W| 3400W
Current| 12A| 16A| 15A| 15A
Dimension| 14.17W x 17.7D x 5.08H in.| 14.8W x 19.7D x 7.3H in.
Weight| 15.65 LBS| 18.96 LBS
Power Range| 1100W/ 2600W| 430W/1800W| 1500W”‘ 3400W| 1500W–3400W
Cord Length| 5.1 feet
Protection Designs| Overheat protection. Automatic hazard detection.Circuit protection sensor.High voltage.20 prevention.Thermostat.

Warning: Changes or modificaons to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for consumer ISM equipment, pursuant to Part 18 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio TV technician for help.

This device complies with part 18 of the FCC rules.
Operation is subject to the following two conditions:

1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.

Your Guarantee
If this product is found to be faulty as a result of faulty materials or workmanship within one year from the date of purchase, it will be repaired free of charge. This guarantee is subject to the following terms:

• Sunpentown must be nofied of the fault.
• Proof of purchase must be presented to Sunpentown’s nominated representative
• The warranty will be void if the product if modified, misused or repaired by an unauthorized person.
• The warranty aer repair will not be extended beyond the original one-year period.
• All replacement parts will be new or reconditioned.
• Parts, which are replaced, become the property of Sunpentown.
• The warranty applies for the use of the product in the USA only.

What is NOT COVERED:

• The warranty does not include freight charges.
• Incidental or consequential damage caused by possible defects with this product.
• Damage to the product caused by improper power supply voltage, accident,fire, floods or acts of nature.
• Failure of the product resulting from unauthorized modificaons to the product.
• Improper installation or failure to perform the necessary maintenance.

This GUARANTEE is in addition to your Statutory Rights
Sunpentown INTERNATIONAL INC
14625 Clark Ave. City of Industry, CA 91745
Tel: 800-330-0388
service@sunpentown.com
www.sunpentown.com

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>