DAEWOO WDS301 Door Sensor Installation Guide
- June 9, 2024
- Daewoo
Table of Contents
DOOR SENSOR
WDS301
DAEWOO SECURITY Alarm system accessories
QUICK INSTALLATION GUIDE
IN THE BOX
YOUR GARAGE DOOR SENSOR
PRECAUTIONARY USE
-
When installing, do not give the transmitter too much impact.
-
Avoid using it in an environment with strong magnetic field and high current.
-
For the transmitter with indicator lights, if the power of the battery (battery) exceeds the maximum power, the LED will be damaged, its life will also be considerably reduced.
If the power is below the specified range, the LED dims or does not light. -
The transmitter must not be in contact with water or corrosive materials.
INSTALLATION ON THE APPLICATION
After successfully installing your AM301 central to your
Daewoo Home Connect control app, you can add your door sensor.
- To do this, click on “add an accessory ” from the page of your AM301 control unit.
- Remove the security tab from your device and separate the two parts of the contactor.
- The application then detects your accessory, confirm the addition.
- Install your contactor within your home as shown below.
INSTALLATION ON STANDS
DOOR CONTACTOR
- First, wipe down the door or window area and apply double-sided tape to the bottom.
- Door sensor transmitter (large) and door sensor magnet (small) need to be installed separately. The triangular marks on the transmitter and the magnet should face each other, and the distance between the two is less than 0.6″.
- When the door or window is opened after installation, the light will turn on for 2 seconds to indicate that the installation is complete.
MAINTENANCE
Do not hesitate to consult the assistance page of our website to answer the
problems encountered with this device.
www.daewoo-security.fr
You have not found the answer to your question ?
Our technical department can be contacted by e-mail at the following address:
support@daewoo-security.fr
STANDARS
**** This product bears the selective sorting symbol for waste electrical and
electronic equipment (WEEE). This means that this product must be handled
pursuant to European Directive 2012/19/EU in order to be recycled or
dismantled to minimize its impact on the environment.
For further information, please contact your local or regional authorities.
Electronic products not included in the selective sorting process are
potentially dangerous of hazardous substances.
In compliance with European Laws. This product is in the essential
requierements and other relevant provisions of Directive 2014/53/EU ( RED )
substances
This product was designed and manufactured in compliance with Directive
2011/65/EU of the European Parliament and of the Council on the restriction of
use of certain hazardous substances in electrical and electronic equipement (
RoHS Directive – RoHS ) and is deemed to comply with the maximum concentration
values set by the European Technical Adaptation Committee ( TAC )
Manufactured in China
References
- SECURITY Développement informatique
- Daewoo | Systèmes de sécurité personnalisables et sans abonnement.