AWE C7 AFM Disabler Chevrolet Corvette User Guide
- October 30, 2023
- AWE
Table of Contents
AWE C7 AFM Disabler Chevrolet Corvette User Guide
Parts List
Symbol | Part Number | Description | QTY |
---|---|---|---|
110073 | C7 Valve simulator bracket | 2 | |
7130K59 | Cable tie | 4 |
NOTE: Always refer to the manufacturer’s service manual for precise
torque specifications onall OEM fasteners.
CAUTION: The exhaust may be VERY HOT — allow adequate time for the system
to cool down before disassembly. Severe burns and injury will occur if skin
comes into contact with a hot exhaust system.
Step 1
Locate and remove the AFM valve motors form the OE exhaust.
Note: You will reuse the OE bolts, to attach the valve motor to the AWE
bracket
Step 2
You will need to flip the OE valve motor arm for proper operation. To do this
remove the 1 torx bolt in the center of the arm, as shown in by the arrow in
Figure 2-1. Next flip the OE valve arm over, as shown in Figure 2-2 and
reinstall the OE torx bolt.
Step 3
Using the OE bolts removed earlier, attach your AWE C7 AFM Disabler to the OE
valve motor, as shown in Figure 3.
Step 4
Safely secure the valve disabler assembly tothe vehicle using the supplied
cable ties.
Make sure to mount the assembly away from any moving parts or high temperature
areas.
Troubleshooting
Issue | Solution |
---|---|
Exhaust is not fitting correctly | Most fitment issues are due to improperly |
adjusted exhaust. This includes tip fitments and rattling due to chassis
contact. Check out our fitment guide for more installation tips.
Incorrect or missing parts| Double check the parts list for your system and
compare them with what you received. Fill out our contact form, found below
and let us know what parts you need.
Care
Once installed properly, your AWE exhaust will provide years of trouble-free performance. The exhaust volume and sound will settle with usage; 800-1000 miles is required to break-in new exhaust systems. Also, please note that the rear 180Technology® resonator has a small drain hole to allow condensation to escape. Water drops from this area are normal. Periodic cleaning of exhaust tips is necessary to maintain proper finish, especially in areas prone to road salt and caustic deicing solutions. Use a mild soap and water solution or car wax to clean the finish. Avoid using abrasive polishes, as they can scratch the finish.
Any questions or comments, please do not hesitate to contact us:
AWE
215-658-1670 CONTACT FORM
Warranty
Up-to-date warranty information is found HERE.
References
- AWE
- AWE
- Contact - AWE
- Frequently Asked Questions - AWE
- AWE SUPPORT, RETURNS AND ISSUE RESOLUTION - AWE
- Warranty, return, cancellation policies - AWE
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>