TCL Linkzone MW63 4G LTE Cat6 Mobile Hotspot User Manual
- October 30, 2023
- TCL
Table of Contents
CJB73U0LCAGA
V1.0 | MW63
Overview
Buttons
1. Power button| • Press and hold for 3 seconds to power on or off your
device.
• Press and hold for 10 seconds to reboot your device.
---|---
2. Micro USB port| Connect to a power supply (5 V/1 A) using the provided USB
cable.
NOTE The provided USB cable is intended for charging only.
Status LED
1. Signal Indicator| • Solid blue: the device is connected to network.
• Solid red: SIM card or network service is not available.
• Blinking blue: the device is disconnected from the network.
---|---
2. Wi-Fi Indicator| • Solid blue: Wi-Fi is enabled.
• Off: Wi-Fi is off.
3. SMS Indicator| • Solid blue: new message(s).
• Flashing blue: SMS inbox is full.
• Off: No new message.
4. Battery Indicator| • Solid blue: battery level: 21% – 100%
• Flashing blue: the device is charging
• Solid red: battery level is low.
| 1. Micro SIM card slot | Insert a micro SIM card into the slot. |
|---|---|
| 2. Reset button | se a paperclip to press the button for 3 seconds |
to reset the device.
Insert the SIM Card & Battery
Note: Heed the orientation
of your SIM card. Make sure you align the SIM card with the slot and slide it
into the slot until it sits properly.
Power On
Connect to the Network
Note: The default Wi-Fi name and password can be found on the
label inside your LINKZONE.
Configure the Network
Note: For the default login information, refer to the label inside your LinkZone.
To configure the LINKZONE Wi-Fi network:
- Open a web browser on the device connected to the LINKZONE network.
- Go to the login website and follow the on-screen instructions. The login website can be found on the label beneath the battery.
Note: For a full user manual, check the Help section on the login website.
General Information
- Manufacturer: TCL Communication Ltd.
- Address: 5/F, Building 22E, 22 Science Park East Avenue, Hong Kong Science Park, Shatin, NT, Hong Kong Visit the TCL website at https://www.tcl.com/mx for tutorials and answers to frequently asked questions, and to download the User Manual.
- To get support for your device, visit the TCL website (https://www.tcl.com/mx/es/service-support-mobile.html), or dial the number listed below:
Argentina: 0810-999-1099
Chile: +56 22 958 96 94
Colombia: 18009520823
Ecuador: 800000635
Mexico: 8008909908
Peru: 080000698
The Dominican Republic: 8887600164
Uruguay: 405296624
Venezuela: 08001005368
Important Safety Information
Read all the safety information before using your device. Failure to follow these safety instructions could result in injury, or damage to your device or other property. The manufacturer disclaims any liability for damage, which may result as a consequence of improper use or use contrary to the instructions contained herein.
Safety and handling instructions
-
Do not use the device in areas where wireless devices are prohibited.
-
When the device is switched on, it should be kept at least 15 cm from any medical device such as a pacemaker, a hearing aid, or an insulin pump.
Consult your physician and medical device manufacturer for information specific to your medical device. -
Do not let children use the device and its accessories without supervision.
-
Always handle your device with care, and keep it in a clean and dust-free place.
-
Do not attempt to repair the device yourself.
-
Do not drop, throw, or bend your device.
-
Do not dispose of the device and its accessories in a fire.
Power adapter
Charge your device with the supplied USB cable. Only charge with an adapter
that is compliant with the applicable international and regional safety
standards.
The adapter shall be CE-approved. Using other adapters could cause damage to
the device or pose a risk of injury or death. Keep the adapter in a well-
ventilated area when it is plugged into an electrical outlet.
Don’t use damaged power adapters.
Recommended adapter specifications
Input voltage/AC frequency| 100~240 V, 50/60 Hz
Output voltage/current/power| 5.0 V/1.0 A/5.0 W
Battery
CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
In accordance with air regulations, the battery of your product is not fully
charged. Please charge it first.
- Do not attempt to open the battery (due to the risk of toxic fumes and burns).
- Do not puncture, disassemble, or short circuit the battery.
- The battery must be recycled or disposed of separately from household waste. Dispose of batteries according to your local environmental laws and guidelines.
- Replace the battery only with another qualified battery. Use of an unqualified battery may present a risk of fire, explosion, leakage, or other hazard.
- Do not use damaged battery.
Operating environment
Your device is designed to work best in ambient temperatures between 0 °C
and 45 °C (32 °F and 113 °F), and should be stored in ambient temperatures
between –10 °C and 70 °C (14 °F and 158 °F). Your device may malfunction if
operated or stored outside of these temperature ranges. Avoid exposing the
device to dramatic changes in temperature or humidity.
Waste disposal and recycling
The device, accessory and battery must be disposed of in accordance with
locally applicable environmental regulations.
This symbol on your device, the battery, and the accessories means that these
products must be taken to:
- Municipal waste disposal centres with specific bins.
- Collection bins at points of sale.
They will then be recycled, preventing substances being disposed of in the environment.
Radio waves
THIS DEVICE MEETS THE GOVERNMENT’S REQUIREMENTS FOR EXPOSURE TO RADIO WAVES.
The exposure standard for devices employs a unit of measurement known as the
Specific Absorption Rate, or SAR. The SAR limit set by public authorities such
as the Federal Communications Commission of the US Government (FCC), or by
Innovation, Science and Economic Development Canada (ISEDC), is 1.6 W/kg
averaged over 1 gram of body tissue. Tests for SAR are conducted using
standard operating positions with the device transmitting at its highest
certified power level in all tested frequency bands.
This device is complied with SAR for general population /uncontrolled exposure
limits in ANSI/IEEE C95.1-1992 and had been tested in accordance with the
measurement methods and procedures specified in IEEE1528.
The FCC has granted an Equipment Authorization for this model device with all
reported SAR levels evaluated as in compliance with the FCC RF exposure
guidelines. SAR information on this model device is on file with the FCC and
can be found under the Display Grant section of
www.fcc.gov/oet/ea/fccid after searching on
FCC ID: 2ACCJB188 The highest SAR value for MW63AF when tested is 1.25 W/Kg
for use close to the body.
While there may be differences between the SAR levels of various devices and
at various positions, they all meet the government requirement for RF
exposure.
While there may be differences between the SAR levels of various devices and
at various positions, they all meet the government requirement for RF
exposure.
For body-worn operation, the device meets FCC RF exposure guidelines provided
that it is used with a non-metallic accessory with the router at least 10 mm
from the body. Use of other accessories may not ensure compliance with FCC RF
exposure guidelines.
Additional information on SAR can be found on the Cellular Telecommunications
& Internet Association (CTIA) Web site: http://www.ctia.org/
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna;
- Increase the separation between the equipment and receiver;
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected;
- Consult the dealer or an experienced radio/ TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. For the receiver devices associated with the operation of a licensed radio
service (e.g. FM broadcast), they bear the following statement:
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- This device may not cause harmful interference;
- This device must accept any interference received, including interference that may cause undesired operation.
Your device is a transceiver that operates in FDD LTE (Band 2/4/5/7/28/66),
UMTS/HSPA/HSPA+ (Band 1/2/4/5/8).
Privacy statement of device usage
Any personal data you shared with TCL Communication Ltd. will be handled in
accordance with our Privacy Notice. You can check our Privacy Notice by
visiting our website: https://www.tcl.com/global/en/communication-privacy-
policy
Disclaimer
There may be certain differences between the user manual description and the
device’s operation, depending on the software release of your device or
specific operator services. TCL Communication Ltd. shall not be held legally
responsible for such differences, if any, nor for their potential
consequences, which responsibility shall be borne by the operator exclusively.
V1.0 | MW63AF
Documents / Resources
| TCL
Linkzone MW63 4G LTE Cat6 Mobile
Hotspot
[pdf] User Manual
MW63, CJB73U0LCAGA, Linkzone MW63 4G LTE Cat6 Mobile Hotspot, Linkzone MW63,
4G LTE Cat6 Mobile Hotspot, LTE Cat6 Mobile Hotspot, Cat6 Mobile Hotspot,
Mobile Hotspot, Hotspot
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>