JimsMaison BT C2173MO WH One Piece Dual Plush Toilet Installation Guide
- October 30, 2023
- jimsMaison
Table of Contents
JimsMaison BT C2173MO WH One Piece Dual Plush Toilet
To ensure this product is installed properly, please read these instructions
carefully before you begin.
(Certain installations may require professional help.) Also be sure your
installation conforms to local codes.
CAUTION: HANDLE WITH CARE. VITREOUS CHINAWARE FRAGILE WITH SHARP EDGES IF
BROKEN.
RECOMMENDED TOOLS AND MATERIALS
- Putty Knife
- Hacksaw
- Flathead Screwdriver
- Flexible Supply Hose
- Adjustable Wrench
- Water Supply Kit
- Sealant
- Carpenters Level
- Tape Measure
INSTALLATION INSTRUCTIONS
REMOVE OLD TOILET
- Turn off water supply valve and flush tank completely. Towel or sponge remaining water from tank and bowl.
- Disconnect and remove old water supply line. NOTE: If replacing valve, first shut off main water supply!
- Remove old mounting hardware, remove toilet and plug floor flange to block sewer gases from escaping.
- Remove closet bolts from flange and clean away old wax, putty, etc. from base area.
NOTE: MOUNTING SURFACE MUST BE CLEAN AND LEVEL BEFORE NEW TOILET IS INST ALLED.
ROUGHING-IN DIMENSIONS:
NOTE: Distance from wall to closet flange centerline must be as listed on
chart:
INSTALL CLOSET BOLTS
Insert floor bolts into flange channel with bolt head down (use plastic
retaining washers to hold the bolts in full-length. Floor bolts should be
parallel to wall and 6″(152mm) apart.
INSTALL WAX RING
Turn toilet bowl down onto a towel or cushioned surface. Place the wax ring
around the draining outlet of the bow and press firmly enough. Apply a thin
bead of sealant around toilet base.
POSITION TOILET BOWL ON FLANGE
- Unplug floor waste opening.gently place the bowl in position with the floor bolts protruding up through the hole in the base.
- Press down with slight twisting motion on the top center of bowl to compress the wax ring creating a water-tight seal.
- Place plastic disc, metal washers and nuts on floor bolts.
