INSIGNIA NS-DWR3SS1 Top Control Built In Dishwasher User Manual
- October 30, 2023
- Insignia
Table of Contents
INSIGNIA NS DWR3SS1 Top Control Built In Dishwasher
Frequently Asked Questions
| ).push({});CODE | DESCRIPTION | POSSIBLE CAUSE | POSSIBLE SOLUTION |
|---|---|---|---|
| El | Either the water flow is insufficient or the water pressure from the | ||
| incoming line is too high | •The water faucet is not open |
•Water pressure is too low
•Drain hose is plugged
•Other (parts failure of inlet or drain system)| •Make sure that the water is
turned on to your dishwasher
•Make sure that the water pressure is 20-100 psi
•Make sure that the drain hose is not Plugged
•Contact Customer Service
E3| Abnormal heating| Dishwasher not reaching defined temperature after DO
minutes| Contact Customer Service
E4| Overflow or leak sensor activated| •A leak in the dishwasher
•Too much water in the tub| •Turn off water to the dishwasher, then check the
filter system for blockage. Unblock if necessary.
•If there is no water in the tub, contact Customer Service
E6| Thermister open circuit| | Contact Customer Service
E7| Thermister short circuit| | Contact Customer Service
Ed| Communication exception or issue| The display board can't receive or the
main board can't send a signal for over 20 seconds| Contact Customer Service
E9| Button pressed for over 30 seconds| Button stuck| Contact Customer Service
14: Why does the dishwasher sometimes start automatically when | close the door? " answer-13="In most cases this is caused by the mounting screw, located under the counter edge, coming too close to or touching the control panel. Make sure the screw is tight and that there is at least a 1/8" gap between the head of the screw and the control panel surface when the door is closed. " image-13="" count="14" html="true" css_class=""]
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>