QUADRA-FIRE 2700-I ACT Wood Burning Fireplace Instructions
- October 30, 2023
- QUADRA-FIRE
Table of Contents
QUADRA-FIRE 2700-I ACT Wood Burning Fireplace
BRICK REPLACEMENT INSTRUCTIONS
The firebox of your Quadra-Fire 2700-1 Insert is lined with high quality firebrick which has exceptional insulating properties. There is no need for a grate, simply build a fire on the firebrick floor.
- Be certain coals are completely cold. Remove all old brick and ash from unit and vacuum out firebox.
- Remove new brick set from box and lay out to diagram as shown.
- Lay bottom bricks in unit.
- Install rear bricks on the top of the bottom bricks. Slide top of bricks under clip on back of firebox wall and push bottom of brick back.
- Install side bricks. Slide top of brick under clips on side of firebox and push the bottom of the brick until it is flush with the side of the unit.
| Nbr. | Brick Size | Qty |
|---|---|---|
| 1 | 9 X 4-1/2 X 1-1/4″ | 11 |
| 2 | 9 x 4-1/2 x 1-1/4″ with hole | 1 |
| 3 | 4-1/2″ X 4-1/2 X 1-1/4 | 1 |
| 4 | see diagram | 2 |
| 5 | see diagram | 2 |
| 6 | 7-3/4″ X 2-1/2 X 1-1/4″ | 2 |
Use Part No. 832-0550 when ordering individual brick and provide brick dimension or copy this page and mark the desired brick and take it to your authorized dealer.
BAFFLE REMOVAL & INSTALLATION
-
Remove all ash from firebox, and extinguish all hot embers before disposal into a metal container.
-
Remove ceramic blanket and baffle together.
-
With a 3/16 Allen wrench, remove the front manifold tube retainer bolts on the air channel under the end of the front tube. See Figure 20.1.
NOTE: Soak the bolts with penetrating oil for at least 15 minutes before trying to remove it. -
To remove manifold tube, slide the tube to one side until one end is out of its hole. T hen, while lifting that end of the fiber board baffle, pull tube up over the air channel and out of hole at the other end.
-
Slide fiber board baffle forward to front of stove and straight out through door. See Figure 20.2.
- To install the fiber board baffle, repeat steps 2 through 4 in reverse. Be sure the fiber board baffle and ceramic blanket are fully pushed back into position.
NOTE: Manifold tubes #1 and #2 have the same size air holes, however tube3 has smaller air holes.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>