BOSCH 9000136689 Induction Hob Instruction Manual

October 30, 2023
Bosch

9000136689 020726
Installation instructions

9000136689 Induction Hob

BOSCH 9000136689 Induction Hob - Product Overview 1

Safe installation

Follow these safety instructions when installing the appliance.

  • Electrical connection must only be carried out by licensed specialist staff. Incorrect connection will invalidate the warranty.
  • The safe operation of this appliance can only be guaranteed if it has been installed to a professional standard in accordance with these installation instructions. The installer shall be liable for any damage resulting from incorrect installation.

Built-under

Do not install refrigerators, dishwashers, non-ventilated ovens or washing machines underneath the appliance.

  • If you fit a modular or compact dishwasher of the same brand underneath the appliance, the worktop must be at least 40 mm thick.
  • If you fit an oven below the appliance, the worktop must be at least 20 mm thick, in certain cases even thicker. Observe the information in the oven installation instructions.
  • Make sure that projecting parts such as the mains housing or the mains cable do not collide, e.g. with a drawer.

Intermediate floor

If the underside of the hob can be touched, an intermediate floor must be fitted.

  • Ask your specialist retailer for an intermediate floor as an accessory.
  • If you use your own intermediate floor, the minimum distance to the mains connection of the appliance must be 10 mm.

Preparing the units

The worktop must be level, horizontal and stable.

  • The fitted units, including wall finishing strips, must be heat-resistant to at least 90 °C.
  • Niche cladding within 50 mm of the back wall must not be combustible (e.g. tiles, stone).
  • Seal the cut surfaces to make them heat-resistant.
    This prevents the worktop from swelling as a result of moisture.
    → Fig. 1

Installing fixing rails

For stone work surfaces, bond the fixing rails in place.
→ Fig. 2

Electrical connection

To protect the appliance, do not remove it from the polystyrene trays until you press the appliance into the cut-out. Never lay the appliance down flat on its side.

  • Check the household wiring before connecting the appliance.
  • The appliance fulfils the requirements of protection class I and must only be operated in conjunction with an earth conductor.
  • In the permanent electrical installation, a partition must be provided in the phases in accordance with the installation regulations.
  • If appears on the appliance’s display, it has not been connected correctly. Disconnect the appliance from the mains and check the connection.

Connecting without a pre-installed cable
Only connect the hob in accordance with the connection diagram.

  • If required, install the enclosed copper bridges.
  • The power cable must correspond to type H05 VV-F or a higher rating.
  • Use the current load to determine which wire cross-section you require. A cross-section of < 1.5 mm² is not permitted.

Installing the hob

Do not trap the power cable and do not route it over sharp edges.

  • If the oven is a built-under type, route the cable along the rear corners of the oven to the mains socket.
  • Push the hob in until it locks into place.
    → Fig. 3

Removing the hob

  1. Disconnect the appliance from the power supply.
  2. Push out the hob from below.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals