degrii Zima Pro Cordless Robotic Pool Cleaner User Manual

degrii Zima Pro Cordless Robotic Pool Cleaner User Manual

Designed in California – Made in China
Degrii, Inc. – wwwdegrii.com
101 Jefferson Drive, 1st Floor, Menlo Park, CA 94025

Warning

1. For your safety, DO NOT do anything other than the routine cleaning and maintenance as described in this manual. This product must be serviced by a professional who is licensed and qualified in pool equipment repair as per local laws.
2. USE ONLY the original and authorized power adapter and cord to charge.
3. DO NOT use if the power cord is damaged. Before charging make sure that the connector and socket are dry and clean.
4. Make sure the electrical outlet is protected by a ground fault interrupter (CFI) or an earth leakage interrupter (ELI).
5. DO NOT let the floating battery platform fal into the pool, or get wet WHILE CHARGING.
6. DO NOT attempt to charge the ZIMA PRO when the robot is running, Make sure the power is OFF.
7. DO NOT ENTER the pool while the pool deaner is in the pool
8. Improper installation and/or operation may void the warranty.
9. DO NOT use an unauthorized extension cord.
10. TO reduce the risk Of injury, DO NOT allow children to operate or ride on the cleaner.
11. When the device battery is charging, the cleaner should be kept in a cool place to avoid damage to internal electrical components caused by overheating,
12. TO ensure optimal battery life for the product during long-term storage, it is recommended to perform a minimum Of one charge cycle per month, maintaining the battery charge level between 30% to 50%. DO NOT let the device remain without battery life for more than a month.
13. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use Of the appliance in a safe way and understand the hazards involved- Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.

WARNING: use only with DZ072ADL2S5250F battery charger.

Warranty

BEFORE INSTALLING AND USING THIS PRODUCT, PLEASE READ THE FOLLOWING GUIDELINES AND INSTRUCTIONS:

1. The warranty duration for the battery and motors is two years from your purchase date.
2. The warranty duration for the scrubbing brushes (4x) and filter cartridges (2x) is one year from your purchase date.
3. This warranty is valid only for the original purchaser and does not apply to resale or transfer.
4. Any damages or failures caused by misuse, unauthorized repair, disassembly, or moisture getting inside the charging port may void the warranty.
5. Purchasing order number or official record is required to claim the repair during the warranty period.

Find the product’s serial number under the floating battery platform. If service is required, please Contact your original dealer. If your Original dealer does not perform warranty services, please find the customer service contact info.*

Introduction

THANK YOU FOR CHOOSING ZIMA PRO
Your Zima Pro Cordless Robotic Pool Cleaner is designed and manufactured to be sustainable and energy-efficient, convenient and cost-effective, easily installed, with minimal maintenance. Zima Pro has a floating battery platform, Bluetooth and Wi-Fi connections, water purification capabilities, and a wall- climbing feature that cleans the pool’s floor, walls and waterline automatically, utilizing eight sensors, four LED lights, four scrubbing brushes, and three motors.

Customer Service

Telephone: +1 (888) 533-4744
Email: happycustomer@degrii.com
Join the community: degrii.com/pages/community
Find the latest manual & FAQ: degrii.com/pages/support

In The Box

Note
Each unit has been tested for overall quality, then cleaned, dried and packed. Due to long-distance transportation, the sponge in the scrubbing brush may still be wet due to evaporation, which can cause dampness in the product

Setup

You can connect and control the ZIMA PRO robot with the Degrii App. The App is available for download from the Google Play Store and the Apple App Store.

Once you download the Degrii App and the device is connected to WI-FI, the App will allow, you to control the cleaner from anywhere at anytime. The App provides many more options to control the robot, giving you a better user experience than standard controls.

To Start The Degrii App

1. Ensure the Wi—Fi router has sufficient signal strength (currently supports 2.4 GHz frequency).
2. Enter your Wi-Fi network name and password.
3. Tum Bluetooth on for your iOS or Android devices.
4. Confirm that your mobile smart device is connected to your home/pool Wi-Fi network,
5. If you are an Android user, check that your GPS and location services are on.

To Prepare Your Robotic Pool Cleaner

Activate Your Robot Using the App on Your Phone

1. Once you open the App, click “Agree” to allow all the required permissions.
2. Click “Sign Up” to create a new user account. Or if you previously set up an account in this App, click “Log In” to access the systems.
3. Search for your robot manually to pair.
4. Connect to the home/pool Wi-Fi network.
5. Enter the Wi-Fi password.
6. Enter the pool shape and size correctly. (‘This information will be used to estimate total cleaning time.)
7. A congratulatory page Will appear once the robot is connected to the App and ready for operation,

Note: Check *sat you are using most updated version of the APP. (The firmware up—to-date.)

In the App

Note: First it is required to put the cleaning robot in the water to control the running operations with the App (Zima Pro does NOT work on land.)

Device Instructions

Indicators On the Floating Battery Platform

• Power On: Battery, Wi-Fi, and Mode LED lights are on.
• Charging indicator: The battery I FD light is blinking.
• Battery Life: Four LED fights represent battery life.
• Battery is Full: All the battery LED lights are on,
• Waiting to Pair: Wi-Fi LED light starts blinking,
• Connection: We-Fi LED light is always on.
• Disconnection: Wi-Fi LED light is off.
• Wi-Fi Reset Indicator: Tum on the device. Then press and hold the “Mode” button for 5 seconds. Reset is done when the Wi-Fi LED light starts blinking.
• Factory Reset Indicator: Turn on the device. Then ack and hold the “Start/Standby” button for 5 seconds, Reset is done when all eight indicator lights are on, then off, and the Wi-Fi icon starts blinking.

Indicators On the Cleaning Robot

• Moving Forward: Two LED lights from the front side are on.
• Moving Backward: Two LEO lights from the back side are on,
• Moving Left: TWO LED lights the left side are
• Moving Right: Two LED lights from the right side ere an,
• Disco Mede is On: All the LED lights are in disco mode.
• Blinking Mode is On: All the I FD lights are blinking.

To turn an end check these LED indicator lights, go to manual mode in the App.

General Cleaning Operations

Replacement Operation

Troubleshooting

Product Specification

FCC Statement

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Any Changes or modifications not expressly by the party responsible for compliance could void the user’s authority to operate the equipment.

This equipment has been tested and found to con-ply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules- These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced technician for help.

The antenna(s) used for transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be collocated or operating in conjunction with any other antenna or transmitter, End-Users must be provided with transmitter operation conditions for satisfying RF exposure compliance.

Canada Statement

This device contains license-exempt that comply with Innovation,
Science and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:
This device may not cause interference.
This device must accept any interference, including interference that may cause undesired operation of the device.

Caution
Read the manual and follow the instructions accordingly. In case Of inappropriate use, Degrii is not liable for losses or injuries.

1. The Pool cleaner must be installed and operated as specified.
2. This device must be installed to provide a separation distance of at least 20cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter
3. Under Industry Canada/Europe/Australia regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain for the transmitter by Industry Canada/Europe/Australia.
4. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the device-
5. When not in use, please store the pool cleaner in a shaded area, away from direct sunshine or any heat source. (We recommend taking the cleaner out of the water after each use).
6. Always clean the filter canister after each use. Do not let the filter baskets dry out before cleaning.
7. Don’t run the cleaner when it is not in the water.
8. Use the pool cleaner in the following water condition:

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>