degrii THP Remote Thermostat User Guide
- October 30, 2023
- degrii
Table of Contents
degrii THP Remote Thermostat User Guide
QUICK START GUIDE
WELCOME TO Degrii
Hello and welcome to Degrii. You made an excellent choice in joining the Degrii family by opting for our edge-cutting smart remote thermostat. We provide you with a complete home climate control system that works with the Degrii smart thermostat. Control your room climate at your own convenience and at the comfort of your room or from the Degrii app. We have a dedicated support team who are always available to help you troubleshoot your Degrii products. We’re excited to have you on our team!
IN THE BOX
DISPLAY SCREEN GUIDE
SETUP
-
Rotate the base 180 degrees upwards. Gently push the release latch at the top and pull the base to open. Insert the included batteries into the sensor’s battery compartment.
-
Open the Degrii app and tap on the Degrii smart thermostat in the app. Tap the sensor icon at the top.
-
Wait a few seconds for the app to display all discovered sensors. Follow the in-app instructions to finish the set up.
-
Mount the remote thermostat at least 5 feet above the ground. To prevent signal shielding, do not mount the remote thermostat on or near metallic surfaces. Take care not to block the PIR motion sensor.
Low Battery Alert
Replace the battery when the battery level is low. The battery level is displayed at the top of the remote thermostat’s display.
Reset
Tap both the right and left buttons on the screen together 3 times to reset the Wi-Fi of the remote thermostat.
COMBINATIONS
CAUTION
- Do not ingest the battery. Chemical Bum Hazard. This product contains batteries. If a battery is swallowed, it can cause severe internal burns in just 2 hours and lead to death. Keep new and used batteries away from children. If the battery compartment does not close securely, stop using the product and keep it away from children. If you think a battery might have been swallowed or placed inside any part of the body, seek immediate medical attention.
- Risk of explosion if the battery is replaced with an incorrect type.
- Do not place the sensor in direct sunlight.
- Degrii Room Sensor is not weatherproof.
- Degrii Room Sensor is not IP rated and is not intended for outdoor use.
- If the equipment is used in a manner not specified by the manufacturer, the protection provided by the equipment may be impaired.
- Do not operate in conditions above 90% humidity, as this can cause condensation/icing/fog and result in damage.
FCC WARNING
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate this equipment. This
device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) This device must accept any interference received,
including interference that may cause undesired operation. This equipment has
been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 ofthe FCC Rules.
These limits are designed to provide reasonable protection provide protection
against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, frequency if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/lV technician for help.
FCC RADIATION EXPOSURE STATEMENT
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
ISEDC RSS WARNING
This device complies with Innovation, Science and Economic Development Canada Compliance licence-exempt RSS standard (s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
ISEDC RADIATION EXPOSURE STATEMENT
This equipment complies with ISEDC RF radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
SPECIFICATIONS
Model: THP
Bluetooth: BLE 5.0
Display: LCD
Input: 3VDC
Weight: 2.82 oz (80 g)
Dimensions: 78mm x 78mm x 26mm
Battery type: AAA Alkaline Battery x 2
Battery life: 2 years*
Operating temperature: 20°F-122°F
Humidity range: 5%-95% RH (no condensation)
Motion sensor range: 17 ft
- Battery Life is based on laboratory test results. Actual results may vary based on usage.
WARRANTY
Your Degrii product is covered by a one-year limited warranty. You can view the limited warranty terms at https://degrii.com/return-warranty-policy or request a copy by contacting Degrii at www.degrii.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>