zouzai 4 Inch Ultra Thin Led Recessed Light User Manual
- October 30, 2023
- zouzai
Table of Contents
zouzai 4 Inch Ultra Thin Led Recessed Light
SAFETY INSTRUCTION
zouzai recessed lighting is certified by ETL & Energy Star of a high standard. This can less LED recessed light is IC rated, with more convenient and secure UL connectors. But to reduce the risk of death, personal injury, or property damage from fire, electric shock, and other hazards, please read all warnings and instructions included with and on the fixture box and all fixture labels, please review the instructions carefully before proceeding.
WARNING
RISK OF ELECTRIC SHOCK
-
All electrical connections must be in accordance with local and National Electric Code (N..C.)standards.
-
Consult a qualified electrician if you are unfamiliar with proper electrical wiring connections.
-
Turn off the switch and circuit breaker before installing this LED light. Do not alter, re-locate or remove wiring.
-
Double-check all connections to be sure they are tight and correct.
-
Verify that the supply voltage is correct by comparing it with the luminaire label information.
RISK OF FIRE -
Keep combustibles and other materials that may burn away from lights.
-
The maximum ambient temperature is 104°F. Do not operate the fixture at temperatures higher than it.
CAUTION
RISK OF INJURY
- The knockouts may be sharp. Wear gloves and safety glasses at all times when removing luminaire, installing or performing maintenance.
- Avoid direct eye exposure to the light source while it is on.
- Wear rubber-soled shoes and work on a sturdy wooden ladder.
RISK OF BURN
- Do not touch the enclosure or light source. It is normal for the luminaire surface to heat up during work.
- Allow lights to cool before handling
RISK OF PRODUCT DAMAGE
- Electrostatic Discharge (ESD): ESD can damage LED fixtures. Personal grounding equipment must be worn during all installation or servicing of the unit.
- Do not touch individual electrical components as this can cause ESD, shorten lamp life, or alter the performance
- Do not mix our product with other products (including Zouzai’s light, eg. 4″ and 6″). Mixing junction boxes of different power will lead to the destruction of the product.
- Do not let the product directly into contact with water. Our product is damp-rated but it is not water-proof.
- Do not make or alter any open holes in an enclosure of wiring or electrical components.
- Never connect components under load.
- Please make sure that all wires in and out are wired firmly and sufficiently. If not, there will be a flickering issue or the light will just stop.
IMPORTANT
- Our temperature has been strictly monitored. But the temperature will be slightly different with varied monitors. Please test them before installation on the ceiling wall and see the color if meets your needs.
- If there is anything wrong with our lights, please see the Troubleshooting page. If you could not find an answer on that page, please refer to the Customer Service page and contact us.
ROUTINE MAINTENANCE
LIMITED WARRANTY
- Please make sure the power is off before maintenance.
- To avoid any damage to the product, please do not use any chemical solvents during routine maintenance. To ensure better lighting. please clean the lamp at regular intervals.
- This product is warranted to be free from defects in workmanship and materials for up to 5 years from the date of purchase.
- if it fails to do so. please send us an e-mail. Contact via Email: zouzal_ service@16.3.com
INSTALLATION STEPS
TOOLS REQUIRED: Saw, Measuring Tape, Electrical Wiring (The wire should
be AWG14-18 for application to connect the fixture), Safety glasses, and
gloves. After the removal of the knock-outs (3/4 inch diameter) in step No.2,
additional cable connectors are needed to secure the wires passing through the
knockouts. You could buy the cable connectors as per your need.
To release the wire ends from the plastic terminals, twist the terminals.
- Cut a hole with a 1:1 size of the cutting template.
- Open the junction box and remove the knock-out on the side.
- Run a wire from the power source through the hole.
- Use the connector to tuck the wires according to the color.
- (If the light is color selectable (CCT). flip the switch on the side of the junction hoy to locate the corin’ that on like “
- Connect (tightly by hand) the junction box to the light panel.
- Put the box in the ceiling hole.
- Push up the spring clips.
- Push the light into the ceiling and power it on.
SPECIFICATIONS
COMPONENTS
DIMMER COMPATIBILITY GUIDE
CUSTOMER SERVICE
AT RECE: 12 HOURS a Resptore Loney Back 30-DAY 5-YEAR
QUICK RESPONSE MONEY-BACK WARRANTY
If there is any problem with our For 30 days after the date of For 5 years
after the date of light, please refer to the purchase, and return your Souza
purchase, if there is any issue Troubleshooting page on the product and
receive a full with the product, we will send
back. If you still could not fix this, refund for ANY reason. please contact
us immediately. a new product for free or a full refund. (no need to return
the doesn’t matter if you have purchased the product) installed the product,
we will respond within 12 hours. Under most conditions, we will not require
you to return the purchased items. Sun The fastest way to help us confirm if
you would return the defective ones) t problem is to send us a video of us, we
will be very happy would problematic light to our official email box.
help us to make continuous improvements
Free Replacement
Friendly Reminder
No Repair
After the buyer purchases the product, We sincerely hope to solve the problem
if the product has a quality problem for you. We do not recommend that you
within the scope of the seller’s warranty leave a product rating first because
we service within the service validity period, cannot obtain the contact
information the seller will replace the buyer with through the review/feedback
nor can a new product for free. we obtain your relevant information and
provide you with compensation. Please rest assured that our service aim is to
make customers 100% satisfied. If there is any problem, please contact us as
soon as possible, we will not let you down.
COMMON TROUBLESHOOTING
We are an LED manufacturer with 10-year experience and receive feedback from more than 1000 customers every year. According to our statistics, 95% of customers’ problems are related to the method of installation and the use of a dimmer, which could be solved by customers themselves. To save your valuable time, please read this introduction first to quickly identify the cause, if you encounter any problems. Problems you may encounter
CONTACT US
Contact US
Contact by Ask a Question” on the “soul” Seller Page. (7x24H) Because Amazon’s
information system sometimes can’t successfully receive and send information,
in which case you may not receive our response. We will never be able to reply
to your inquiry. If you find that we have not responded to you within 24
hours, please send us an e-mail.