Sunnydaze GWC-463 Wrought Iron 4 Piece Fireplace Log Holder and Tool Set User Manual
- October 30, 2023
- Sunnydaze
Table of Contents
Sunnydaze GWC-463 Wrought Iron 4 Piece Fireplace Log Holder and Tool Set
User Manual
HELPFUL HINTS
Sunny daze Decor advises reading this manual thoroughly and assembling the item soon after purchase.- Do not fully tighten hardware until instructed to do so. If the hardware is tightened too soon, mounting holes may not align, and parts may not easily fit together.
Tools Required (not included)
Phillips Screwdriver|
8mm Wrench|
14mm Wrench
WARNING
CHOKING HAZARD — This item contains small parts that can be swallowed by
children. Keep children away during assembly.
Inspect packaging to ensure all parts are accounted for before disposing of packing materials.
| No | Parts | Qty |
|---|---|---|
| A | 
Side Panel (L/R) One panel has tool holder built in| 2
B|
Bottom Panel| 1
C|
Back Panel| 1
D|
Bottom Bar| 2
E|
Top Bar| 1
F| 
Axle| 1
G|
Wheel| 2
H|
Tool Set| 3PC
No| Hardware| Qty
---|---|---
1|
M6x30mm Bolt| 4
2|
M5x25mm Bolt| 12
3|
M5 Nut| 12
4|
3/8″ Nut| 4
5|
Washer| 4
ASSEMBLY
Read carefully and understand assembly before beginning. Do not fully tighten bolts until instructed to do so.
STEP 1
A: 1
D: 2
1: 2
NOTE: Side Panels install with the tubular frame on the outside, screen on the inside.
- Align Bottom Bar (D) with Side Panel (A). Loosely secure by hand-tighten M6x30mm Bolt (1).
- Repeat to loosely fasten the remaining bottom bar to the opposite side.
- With the ledge facing upward, and flush with the side panel, secure Bottom Panel (B) to the bottom bars using four M5x25mm Bolts (2) and four M5 Nuts (3).
- Fasten remaining Side Panel (A) to the bottom bars by hand-tightening two M6x30mm Bolts (1).
- Secure Back Panel (C) to the rear of the side panels using six M5x25mm Bolts (2) and six M5 Nuts (3). Do not fully tighten any bolts until after Step 4 is complete.
STEP 2
B: 1
2: 4
3: 4
- With the ledge facing upward, and flush with the side panel, secure Bottom Panel (B) to the bottom bars using four M5x25mm Bolts (2) and four M5 Nuts (3).
Do not fully tighten any bolts until after Step 4 is complete.
STEP 3
A: 1
1: 2
- Fasten remaining Side Panel (A) to the bottom bars by hand-tightening two M6x30mm Bolts (1).
Do not fully tighten any bolts until after Step 4 is complete.
STEP 4
C: 1
2: 6
3: 6
- Secure Back Panel (C) to the rear of the side panels using six M5x25mm Bolts (2) and six M5 Nuts (3)
Tighten all bolts after this step is complete.
STEP 5
E: 1
2: 2
3: 2
F: 1
G: 2
4: 4
5: 4
- Secure Top Bar (E) to the underside of the side frames by hand-tightening two M5x25mm Bolts (2) and two M5 Nuts (3), as shown.
- Run Axle (F) through the holes in the bottom of the side panels.
- Place one Washer (5) onto the axle, then Wheel (G), another Washer (5) and secure with one 3/8″ Nut (4).
- Repeat previous step to attach remaining Wheel (G).
Care & Maintenance
SAFE USE: Only use on a flat, level surface. Do not stand or sit on the
log rack.
GENERAL USE & CARE: Recommended for indoor use only. Manufacturer and
seller are not liable for any damage resulting from exposure to outdoor
elements. Damage from outdoor use and/or normal wear and tear is not covered
by the 1-year product warranty.
INSPECT: Periodically check assembly points and tighten fittings as
necessary. If handles on the tools become loose, simply re-tighten them by
hand.
CLEANING: Use a damp cloth to clean. Do not use abrasive cleaners as
doing so may cause parts to tarnish or rust.
SAFETY STATEMENTS & WARNINGS
- Do not exceed the weight capacity of the log rack.
- Supervise children at all times; do not allow children to play on or play with any part of this product.
- Firmly secure all hardware before use.
- Inspect hardware often and tighten as necessary.
- Do not use the brush to sweep live coals (embers).
- Do not use harsh chemicals or abrasive materials to clean this unit.
- This product is for residential use only; institutional or commercial use will void the warranty
WARNING!
Manufacturer and seller expressly disclaim any and all liability from personal
injury, property damage or loss, whether direct or indirect, or incidental,
resulting from the incorrect attachment, improper use, inadequate maintenance,
or neglect of this product.
Purchase Date: / / Order/Customer Reference Number:
Thank you for choosing Sunnydaze Decor. We stand behind our brand and the
quality of the items we sell.
Replacement parts or products will be sent at our discretion within the 1-year
warranty period. Proof of purchase, with the date of purchase as well as
photos of the merchandise defect, must be provided. Photos are used to
determine the cause of defects and for future quality control. Register your
warranty at https://tiny.cc/SunnydazeWarranty If you have any questions,
comments or concerns, feel free to contact us by phone at 833-982-1977, by
email:
customerservice@sunnydazedecor.com,
or via our contact us page at https://tiny.cc/SunnydazeContact
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>