SARGENT DG1 Removing and Installing Large Format Interchangeable Cores Instruction Manual
- October 30, 2023
- SARGENT
Table of Contents
SARGENT DG1 Removing and Installing Large Format Interchangeable Cores
Product Information
The product is a lock system that comes with Large Format Interchangeable
Cores (LFIC). The lock system can be used with rim and mortise cylinders and
bored locks. The product comes with a control key that is used to remove and
install the cores. The product also includes a tailpiece that is used to
secure the core in place.
The LFIC cores are available in both permanent and disposable types. The
permanent cores can be removed using the control key, while the disposable
cores can be simply pulled out of the lock.
The tailpiece can be saved and re-used with the permanent core.
The product may contain lead, which is known to the state of California to
cause cancer and birth defects or other reproductive harm.
Product Usage Instructions
Removing Cores:
- For rim and mortise cylinders and bored locks, insert the control key and turn it counter-clockwise until it reaches a stop.
- With the key in this position, pull out the core.
- Insert control key and rotate 15° counter-clockwise.
- With key in this position, pull out core.
Installing Cores:
Rim and Mortise Cylinders
- With pins aligned in housing as shown below, and with control key in core, rotate key counter-clockwise and insert core into housing.
- Make sure the key clearance slot faces down.
- Note: Pins should be positioned at about a 15° angle to align with holes in core.
- To remove key, return to vertical position and withdraw.
Note: For easiest key removal, hold core in place while starting to withdraw key.
Lever/Bored Locks
- Insert correct tail piece into back of core and secure with tail piece retainer.
- Install core and tail piece into lock by inserting control key and rotating counter- clockwise. Then, insert core into lock.
To remove key, return to vertical position and withdraw. Note: For easiest key
removal hold core in place while starting to withdraw key.
Note: Tailpiece shown for illustrative purposes only. Refer to lock
series catalog/parts manual for correct tailpiece based on core type.
Important Note:
The tailpiece shown in the manual is for illustrative purposes only. Refer to the lock series catalog/parts manual for the correct tailpiece based on the core type.
- The 11-6300 and DG1, DG2 or DG3- 6300 cores are only compatible with hardware ordered to accept them.
- Existing hardware may require to be modifi ed or require the use of different tail pieces in bored locks.
- See product catalogs for more information.
- Removing Cores keyed 1-bitted use a control key cut 113511.
WARNING
This product can expose you to lead which is known to the state of California
to cause cancer and birth defects or other reproductive harm. For more
information go to www.P65warnings.ca.gov.
1-800-727-5477
www.sargentlock.com
Copyright © 2008, 2009, 2011, 2014, 2022 SARGENT Manufacturing Company. All
rights reserved. Reproduction in whole or in part without the express written
permission of SARGENT Manufacturing Company is prohibited.
The ASSA ABLOY Group is the global leader in access solutions. Every day we
help people feel safe, secure and experience a more open world.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>