SARGENT 988 Surface Bolt Instruction Manual
- October 30, 2023
- SARGENT
Table of Contents
988 Surface Bolt
Instruction Manual
988 / 988CR / 988Y Surface Bolt
988 Surface Bolt
Installation Instructions
INSTALLATION PROCEDURE
Strike Mounting:
- Determine if bolt is to be mounted at top (1-1) or bottom (1-2) of door.
- A 2 ¾ ” backset is recommended.
1-1. Top of Door (frame mounted strike):
- Locate strike on frame as shown and mark hole locations. For Windstorm Strike, factory frame preparation is supplied.
- Drill and tap for ¼ “– 20 machine screws (#8 drill and ¼ “– 20 tap are required).
- Secure strike with three (3) ¼ “– 20 x ¾ “screws (supplied).
1-2.Bottom of Door (floor mounted strike):
- 1-1/8″ dia. x 1½” deep hole required in floor to accept surface bolt.
- Mark and drill two (2) 7/16 ” dia. x 1¼ ” deep holes for strike anchors.
- Secure strike with two (2) anchors and ¼ “– 20 x ¾ ” screws (supplied).
Surface Bolt Mounting:
- Slide knob end retainer to stop pin.
- Locate surface bolt and retainers on door as shown. Mark location of through-bolts.
- Check bolt alignment in strike before drilling holes.
- Drill four (4) 9/32 ” dia. holes through door.
- Open holes for grommet nuts on opposite side of door using “V” size drill.
- Secure retainers to door using grommet nuts and ¼ “– 20 x 2-3/4 ” screws (supplied).
- Check for proper operation.
Item | Description | Qty. |
---|---|---|
1 | Retainer | 2 |
2 | Surface Bolt | 1 |
3 | Flat Mortise Strike | 1 |
4 | Angle Strike | 1 |
5 | Screw, ¼–20 x 2-3/4″ | 4 |
6 | Grommet Nut | 4 |
7 | Screw, ¼–20 x ¾” | 3 |
8 | Anchor | 2 |
9 | Windstorm Strike | 1 |
NOTE: Parts used depend on mounting application.
WARNING
This product can expose you to lead which is known to the state of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65warnings.ca.gov.
Experience a safer and more open world
MEMN8 3/23
1-800-438-1951 • www.assaabloy.com
Copyright © 2017, 2022, 2023, ASSA ABLOY Access and Egress Hardware Group,
Inc.
All rights reserved. Reproduction in whole or in part without the express
written permission of ASSA ABLOY Access and Egress
Hardware Group, Inc. is prohibited.