ZALMAN T8 ATX Mid Tower Computer Case User Manual

ZALMAN T8 ATX Mid Tower Computer Case

Precautions

• Read this manual carefully before installing.
• Check the product and components before installing. If you find any abnormality, contact the location where you purchased the product for a replacement or refund.
• Wear gloves to prevent accidents when installing the product.
• Severe damage may occur when mounting the system, so do not apply excessive force.
• Connecting the cable incorrectly may cause a fire due to a short circuit. Make sure to refer to the manual when connecting the cable.
• Be careful not to block the ventilation hole of the product when using the system.
• Avoid locations with direct sunlight, water, moisture, oil, and excessive dust. Store and use the product in a well-ventilated location.
• Do not wipe the surface of the product using chemicals. (organic solvents such as alcohol or acetone)
• Do not insert your hand or another object into the product during operation, as this may injure your hand or damage the object.
• Store and use the product out of children’s reach.
• Our company assumes no responsibility for any problem that occurs due to the use of the product for purposes other than its designated purposes and/or the carelessness of the consumer.
• The exterior design and specifications of the product are subject to change without prior notice to consumers for quality improvement.

Specifications

Accessories component

1/O Ports

Installations

1. Removing the side panels

2. Removing the front panel

3. Foot Pads Installation

4. Mounting the motherboard

5. Motherboard size

6. ATX

7. mATX

8. Mini-lTX

9. Mounting PCI-E(VGA) card

10. Mounting the ODD

11. Mounting the 2.5″ SSD

12. Mounting the 2.5″ SSD

13. Mounting the 3.5″ and 2.5″ SSD / HDD
    Note
    Please check the HOD size before installing. HOD higher than 25.4mm may not be properly installed in the HDD cage.

14. Mounting the PSU

15. Mounting the radiator

16. Mounting the front radiator

  * 120mm / 240mm
2. Mounting the rear radiator
  * 120mm

12. Mounting the fans
13. Mounting the front fans

  * 120mmx2/140mmx2
2. Mounting the rear fan
  * 120mm
3. Mounting the side fan
  * 120mm

13. Fan(s) Included / Fan Specifications
    Rear

    • Dimensions: 120 x 120 x 25(H)mm
    • RPM: 1,100 ±15%
    • Fan: DC 12V 0.15A±20%
    • Sleeve Bearing
    • Power Connector: FAN-3PIN

14. I/O Connectors

Certification

This mark, designed by Zalman, indicates product compliance with the European Union’s RoHS (Restriction of Hazardous Substances) Directive.

Disposal of Old Electrical & Electronic Equipment
(Applicable in the European Union and other European countries with separate collection systems). www.zalman.com.

References

• zalman.com
• ANDPRO.RU - интернет магазин компьютерной и офисной техники с выгодными ценами и доставкой

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>