Euri Lighting EOL-TL53BLK-1020cec LED Floor Lamp Installation Guide
- October 30, 2023
- Euri Lighting
Table of Contents
Euri Lighting EOL-TL53BLK-1020cec LED Floor Lamp
Product Information
The EOL-TL53BLK-1020cec is a LED fixture suitable for indoor lighting. The package includes a base, bottom tube, middle tube, upper tube, lamp cup, glass shade, and two E26 LED lamps with a power rating of 12W each.
Warnings:
- Review the instructions and warnings listed below prior to proper installation.
Cautions:
- Confirm if all components are present and in good condition.
- Install the correct wattage E26 LED lamp shown on the label.
Product Usage Instructions
Assembly Instructions:
- Align the base, bottom tube, upper tube, and the neck.
- Screw the bottom tube into the base.
- Screw the middle tube into the bottom tube.
- Screw the upper tube into the middle tube.
- Screw the lamp cup into the upper tube.
- Screw in the lamp shade and it will lock together.
- Rotate the clip clockwise and then tighten the screw.
- Install the E26 LED lamp into the socket.
Note:
To remove wire slack from between the base, upper and middle tubes, and neck,
pull the cord from the base after connecting the pieces together.
E26 LED Lamp Installation:
- Insert the E26 base of the lamp into the holes of the socket.
- Twist the lamp clockwise and it will lock securely in place.
PLEASE REVIEW THE INSTRUCTIONS AND WARNINGS LISTED BELOW PRIOR TO PROPER INSTALLATION
SAFETY INSTRUCTIONS AND WARNINGS
WARNINGS
- Risk of fire/electrical shock.
- LED Fixture installation requires knowledge of luminaire electrical systems.
- Risk of electric shock – disconnect power at source before installation.
- Do not make or alter any open holes in an enclosure of wiring or electrical components during installation.
- If the lamp or luminaire exhibits abnormal operation (buzzing, flickering, minimal light, etc.), turn off the power, remove the lamp, and contact us.
For more information please visit www.eurilighting.com or call our toll-free number 1-888-743-5766.
CAUTIONS
- Do not look directly at the operating LED Fixture.
- Do not touch this product with wet hands.
- Do not disassemble, repair or alter the lamp.
- Designed for indoor applications only.
- Suitable for dry locations.
- The luminaires shall be grounded.
- Be careful not to touch the lamp pins to the metal housing when installing.
- This Device is not intended for use with emergency exits or emergency lights.
ASSEMBLY INSTRUCTIONS
General Information:
Confirm if all components are present and in good condition.
- a. Base
- b. Bottom tube
- c. middle tube
- d. Upper tube
- e. Lamp cup
- f. Glass shade
- g. E26 LED Lamp (2*12W)
FIXTURE ASSEMBLY
Note:
To remove the wire slack from between the base, upper and middle tubes, and
neck, pull the cord from the base after connecting the pieces together.
- Align the base, bottom tube, upper tube, and the neck.
- Screw the bottom tube into the base.
- Screw the middle tube into the bottom tube.
- Screw the upper tube into the middle tube.
- Screw the lamp cup into the upper tube.
- Screw in the lamp Shade and it will lock together.
- Rotate the clip clockwise and then tighten the screw.
- Install the E26 LED lamp into the socket.
E26 LED LAMP INSTALLATION
- A – Insert the E26 base of the lamp into the holes of the socket.
- B – Twist the lamp clockwise and it will lock securely in place.
Note:
Please install the correct wattage E26 LED lamp shown on the label
©2020. Euri Lighting | A Division of IRTRONIX Inc. All Rights Reserved.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>