SCHRACK TECHNIK LIPK0001 Maia LED Instruction Manual
- October 30, 2023
- SCHRACK TECHNIK
Table of Contents
Maia LED
LIPK0001, LIPK0002, LIPK0003, LIPK0004
Assembly Instructions
Safety instructions
- Before mounting and maintenance please make sure that the electrical supply has been switched off to avoid electric shock.
- Never look into the light directly when it is switched on.
Danger, installation by electricians only
Serie Maia Led
-
Turn off the power.
-
Use screw driver pushing the A point then open the Back cover counterclockwise.
-
Loosen the screw.
-
Put the back cover on the ceiling ,use marking pen mark the drill hole position. Drill a hole 40mm deep.
Put expansion screw in the hole. Pass the wire through the hole, use screw locking. -
Connect the wire into terminal. Close the wire pressing.
-
Adjust CCT switch and power switch. For version with sensor, see point 9 with sensor settings.
-
Pushing the lamp into back cover as picture position then clockwise rotation until the A point popping.
-
Turn on the power.
Those products contain a light source of energy efficiency class E
Serie Maia Led
Schreck Technik
Schreck Technik GmbH
Seybelgasse 13
AT-1230 Vienna
www.schrack.com