AGT INDUSTRIAL AGT-SSSG72 Skid Steer Grader Owner’s Manual
- October 30, 2023
- AGT INDUSTRIAL
Table of Contents
AGT INDUSTRIAL AGT-SSSG72 Skid Steer Grader Owner’s Manual
TO THE OWNERS
GENERAL COMMENTS
Congratulations for having this Grader! Your Grader was carefully designed and
manufactured to give you years of dependable service. Your Grader will require
some minor maintenance to keep it in top working condition. Please observe all
safety precautions and maintenance procedures aside scribed in this manual.
BEFORE OPERATION
Thoroughly read and understand the instructions given in this manual before
operation. Refer to the “Safety Label” section, read all instructions note don
them. Do not allow anyone to operate his equipment who has not fully read and
comprehended this manual and who has not been properly train dean the safe
operation of the equipment.
SERVICE
Please remember to use only manufacturer replacement parts. Substitute parts
may not meet the standards required for safe, dependable operation.
SAFETY PRECAUTIONS
BEFORE OPERATION
-
The operator must read the operation manual carefully before installation, operation or maintenance. Improper operation will cause the machine damage or the operator death.
-
Read all the safe signs and safe declarations. Follow all the professional
safe terms, local laws or the professional directions. -
Familiar with the Grader about functions, specs and operation. Replace the to-be-damaged parts in time. Make sure all the hydraulic installations and couplings connect firmly, and all the safe signs stick on these table positions clearly.
IMPORTANT
- Operator should be familiar with all functions of the unit. 2. Make sure all guards and shields are in place and secured before operating element.
- Keep all persons away from equipment and work area.
- Dismounting from a moving unit can cause serious injury or death.
- Keep hands, feet, and clothing away from power-driven parts.
- Detach and store implement in an area where children normally do not play. Secure implement by using blocks and supports.
Always wear proper safety glasses, goggles, or a face shield when driving pins in or out, or when any operation causes dust, flying debris, or any other hazardous material.
SAFETY PRECAUTIONS
Operator Safety
- Wear protective clothing and equipment appropriate for the job. Clothing should be snug fitting without fringes and pull strings to avoid entanglement with moving parts.
- Prolonged exposure to loud noise can cause hearing impairment or hearing loss. Wear suitable hearing protection such as earmuffs or earplugs.
- Operating equipment safely requires the operators all attention, Avoid wearing radio headphones while operating machinery.
Tool Safety
- Inspect entire machine before each use. Replace damaged or worn parts.
- Check for fuel leaks and make sure all fasteners are in place and securely fastened.
SAFETY PRECAUTIONS
Wear Protective Equipment
-
Escaping fluid under pressure can penetrate the skin causing serious injury.
-
Avoid the hazard by relieving pressure before disconnecting hydrauliclinesor performing work on the system.
-
Make sure all hydraulic fluid connections are tight and all hydraulic hosesand lines are in good condition before applying pressure to the system.
-
Use a piece of paper or cardboard, NOT BODY PARTS to checkforsuspected leaks.
-
Wear protective gloves and safety glasses or goggles when workingwithhydraulic systems.
-
DO NOT DELAY. If an accident occurs, see a doctor familiar with this type injury immediately. Any fluid injected into the skin or eyes must biter ate within a few hours or gangrene may result.
Transportation and Storing -
Store machine and fuel where fuel vapors cannot reach sour combustion like, water heaters, electric motors, switches, furnaces, etc.
-
Always secure the machine with tie downs or similar restraints when transporting.
-
The machine be stored in a manner that prevents it from falling, rolling or tipping.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>