POWER SOLID PSi800W 800W Low Frequency Inverter User Manual
- June 10, 2024
- POWER SOLID
Table of Contents
POWER SOLID PSi800W 800W Low Frequency Inverter
PRODUCT DESCRIPTION
- POWER ON
- POWER OFF
- LCD
- AC input LED
- Battery LED
- Fault LED
- ESC
- SEL
- ENTER
- RS232
- Fan
- AC input
- AC output
- Battery input
INSTALLATION
Unpacking and inspection
Before installation, please inspect the unit. Be sure that nothing inside the
package is damaged. You should have received the following items inside of
package.
- The unit X 1
- Software CD X 1
- AC input cable X 1
- User manual X 1
- Communication cable X 1
Battery connection
-
Stepl: Away the cover of external battery terminal.
-
Step2: Following battery polarity guide printed near the battery terminal. RED cable to the positive terminal(+); BLACK cable to the negative terminal (-);
WARNING! Please use the appropriate battery cable. Please refer to the following table.- Model: 800W
- Battery voltage: 12V
- Wire size: 2*10AWG
-
Step3: Install a DC breaker in a positive line.
The rating of the DC breaker must be according to the inverter’s battery current 150 A for 12V battery).
Note: you must keep the DC breaker off. -
Step4: Connect battery cable to the external batteries.
Note: For the user operation safety. We strongly recommend that you should use tape to isolate the battery terminals before you start to operate the unit.
OPERATION
- Press “ON” for 2 seconds to turn on the unit. The unit will work automatically in line mode or inverter mode according to input utility status. When “OFF” is pressed and hold for 2 seconds, the unit will be turned off. When machine is working, buzzer can be controlled by pressing “ON”.
- The display panel, shown in below chart, is on the front panel of the inverter. It includes four front indicators, three function keys and a LCD display, indicating the operating status and input/output power information.
LED Indicators & Audible Alarms
There are five LED indicators in the front panel of vertical machine.
There are three LED indicators in the front panel of horizontal machine.
LCD Display
Display Select
The LCD display information will be switched in turns by pressing “SEL” key.
The selectable table information is as following table.
LCD Setting
After pressing and holding “ENTER” button for 2 seconds, the unit will enter
setting mode. Press “ENTER” button to select setting programs. Press “SEL”
button to change parameter. Press “ESC” button for 2 seconds to exit. All the
parameters will take effect, after resetting machine.
Setting program information
If you want to reset all the parameters, pressing “SEL” button for 2 seconds
will enter into reset settings dialog. Please select “DEF” through “SEL”
button. Press “ESC” button for 2 seconds to exit and all parameters will be
default state. Reset machine and all the parameters will take effect.
If float charge voltage is higher than Absorption charge voltage, machine will
alarm. Buzzing buzzer and blinking red LED. Simultaneously, The icon , @TTui],
blinks
Operating Mode Description
Fault Reference Code
COMMUNICATION
Refer to User Guide of SolarPowerMonitor
TROUBLE SHOOTING
If machine enters into fault mode, please remove input power. And according to the table, deal with the following problems.
SPECIFICATION
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>