Klarstein 10035556 QUICK STICK SMART Sous vide User Manual

QUICK STICK
SMART

Sous-vide Stick
10035556
www.klarstein.com

Dear Customer,
Congratulations on purchasing this device. Please read the following instructions carefully and follow them to prevent possible damage. We assume no liability for damage caused by disregard of the instructions and improper use. Scan the QR code to get access to the latest user manual and more product information.

https://use.berlin/10035556

TECHNICAL DATA

SAFETY INSTRUCTIONS

• This device may be only used by children 8 years old or older and persons with limited physical, sensory, and mental capabilities and/or lack of experience and knowledge, provided that they have been instructed in the use of the device by a responsible person who understands the associated risks.

• Keep the appliance under constant supervision while in use. Keep an eye on any children in the vicinity of the appliance when it is in use. The appliance is not a toy.

• Incorrect use of this appliance may cause personal injury and damage the

• Use for its intended purpose only. The manufacturer is not responsible for any injury
  or damage resulting from incorrect use or handling (see also Warranty Terms).

• For domestic use only. Not for outdoor or commercial use.

• Remove all packaging and transport materials from the inside and outside of the

• Check that the appliance has no visible damage and that no parts are missing.

• Do not use with any cords other than that supplied.

• Check that it is not possible to pull or trip over the cord or any extension cord.

• The appliance must not be used together with a timer switch or a separate remote control system.

• Turn off the appliance and remove the plug from the socket before cleaning, or when the appliance is not in use.

• Avoid pulling the cord when removing the plug from the socket. Instead, hold the

• Keep the cord and appliance away from heat sources, hot objects, and naked

• Ensure that the cord is fully extended.

• The cord must not be twisted or wound around the appliance.

• Check regularly that neither the cord nor plug is damaged and do not use the appliance if there is any damage, or if it has been dropped on the floor, dropped in water, or damaged in any other way.

• If the appliance, cord, or plug has been damaged, have the appliance inspected and if necessary repaired by an authorized repairer.

• Connect to 230V, 50 Hz only. The warranty is not valid if the appliance is connected to an incorrect voltage.

• Unauthorized repairs or modifications will invalidate the warranty.

• Only place vacuum-packed foods in the appliance. Do not try to cook unwrapped

CAUTION
Risk of burns! Some parts of this product can become very hot and cause burns. Particular attention should be paid to where children and vulnerable people are present.

DEVICE OVERVIEW

CONTROL PANEL AND KEYS

The control panel consists of an LED display, a timer, temperature control buttons, and a start/stop button.

SETTINGS

Changing the temperature unit

Press and hold the Start/Stop button for about 3 seconds to toggle between the temperature units Fahrenheit and Celsius.

Setting the timer

1. Press the Timer button on the control panel and then the adjustment buttons (+/-) to set the hours.
2. Press the Timer button to save the hour value and then press the adjustment buttons (+/-) to set the minutes.
3. Press the Start/Stop button to save the minute value. The Timer button will flash for about 3 seconds to indicate that the timer is set. Once the water has reached the set temperature, the timer will start the countdown.
   

Change flow direction
The sous-vide stick can circulate water clockwise or anticlockwise. In addition, it can be adjusted to direct the flow rate of the pump sideways into the container to protect sensitive food such as eggs or salmon or to prevent the water jet from being blocked by food.

1. Turn the pump cover clockwise to release it from the motor housing.
2. Position the flow openings on the side of the pump cover as desired. Insert the retaining tabs into the slots, then turn the cap counterclockwise to lock it in place.
   

Calibration of the temperature sensor
The temperature sensor on the sous-vide stick is extremely accurate and is calibrated at the factory. However, if you want the readings on the stove to match those of your
thermometer, follow these steps to recalibrate the sous-vide stick.

1. Determine the difference between the temperature reading on the sous-vide stick and the temperature reading on your thermometer. You can change the display on the stove by up to ± 9.9 °C.
2.  Press and hold the temperature button for about 5 seconds. The display shows 0.0°.
3. Press the adjustment buttons (+/-) to add or subtract up to 9.9 °C.
4. Press the temperature button again to save the set value.
   

OPERATION

|
---|---
1. Make sure that the stove is disconnected from the power source. Attach the
adjustable ring clamp to the side of your pot or container and then clamp it in place.| 2. Insert the sous-vide stick into the adjustable ring clamp.
| 4. Fill the pot with water to a certain level between the MIN and MAX lines on the side of the pump housing.
4| Place the pot/container near a power outlet. Make sure that the pot/container is not placed on a stove or other heat source.
---|---
5| Connect the sous-vide stick to the power outlet.
6| Press the temperature button on the control panel and then the adjustment buttons (+/-) to set the target temperature.
7| Press the Start/Stop button to start cooking.
8| When cooking is complete, press the Start/Stop button to stop cooking.

DEVICE CONTROL BY SMARTPHONE

If you integrate the device into your home WiFi, you can conveniently operate it via the associated Klarstein app. The app not only allows you to remotely control the device via
your smartphone, but also gives you access to recipes and additional information.
Follow these steps to connect your smartphone to your Klarstein device:

1. Download the Klarstein app first by scanning the QR code with your smartphone (see below), or download it directly from App Store or Google Play.
2. Make sure your smartphone is connected to the same WiFi network that your Klarstein device is to be connected to.
3. Open the Klarstein app.
4. Sign in to your account. If you do not have an account, sign up in the Klarstein app.
5. Follow the instructions from the app.

App Download
Use the scan function of your smartphone to scan the QR code and save the app on your smartphone.
Note: The app provides further information on how to use the app and helps on how to connect to your device as soon as you open it for the first time.

iOS

|

Android

---|---

https://apps.apple.com/app/id1479571307#?platform=iphone

|

Troubleshooting connection problems
If your Klarstein device cannot be found in the WLAN, check the following:

• Is the device plugged in?
• Is the WiFi feature of my phone enabled?
• Is the WiFi function of the Klarstein device activated? (Follow the instructions in the app)
• Has the WLAN password been entered correctly?
• Are the router, Klarstein device, and smartphone in the immediate vicinity during the connection attempt? (Ideally no more than 5 m apart)
• If you have deactivated the 2.4 GHz band in the settings of your wireless router, activate it in your router settings.

Note: For further help, follow the instructions in the app when setting up the connection.

CLEANING AND CARE

1. Turn the pump housing clockwise to detach it from the motor housing and then remove it.
2. Turn the pump cover clockwise to release it from the pump housing and then remove it.
3. Clean the pump casing and pump cover in the dishwasher or sink.
4. Use detergent and a soft toothbrush to clean the heating coil, pump shaft, and sensor, then rinse under running water.
5. Allow all parts to dry completely before reassembly.

Note: Make sure that only the metal parts are exposed to the water. Do not expose the upper part of the sous-vide stick (motor housing) to water.

DISPOSAL CONSIDERATIONS

If there is a legal regulation for the disposal of electrical and electronic devices in your country, this symbol on the product or on the packaging indicates that this product must not be disposed of with household waste. Instead, it must be taken to a collection point for the recycling of electrical and electronic equipment. By disposing of it in accordance with the rules, you are protecting the environment and the health of your fellow human beings from negative consequences. For information about the recycling and disposal of this product, please contact your local authority or your household waste disposal service.

DECLARATION OF CONFORMITY

Manufacturer:
Chal-Tec GmbH, Wallstrasse 16, 10179 Berlin, Germany.
Importer for Great Britain:
Chal-Tec UK limited
Unit 6 Riverside Business Centre
Brighton Road
Shoreham-by-Sea
BN43 6RE
United Kingdom
The complete declaration of conformity of the manufacturer can be found at the following link: use.berlin/10035556

References

• Klarstein | Your home. Your kitchen. Your style.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>