marmic C293062 Upper Control Arm Instruction Manual
- June 10, 2024
- marmic
Table of Contents
marmic C293062 Upper Control Arm
Product Information
The Upper Control Arms C293062 are designed to fit the following vehicles: 2001-2010 Chevrolet Silverado 2500HD/3500HD and 2001-2010 Sierra 2500HD/3500HD. These control arms come with a warranty for the ball joints and bushings, with one chance for a free exchange within one year if they go wrong.
Product Usage Instructions
- Use a floor jack to raise the front of the vehicle and place jack stands under the frame. Finish removing the lug nuts and wheel.
- Disconnect ABS and brake line mounting brackets from Upper Control Arms and spindles.
- Mark the control arm’s position before loosening any of the nuts.
- Loosen the upper ball joint nuts until there is a visible gap between the nut and spindle.
- Using a hammer, hit the side of the knuckle attached to the upper control arm’s ball joint. Continue hitting the knuckle until the ball joint has been freed.
- Loosen the control arm nuts on both sides and remove old control arms.
- Install new control arms, adjusting the control arm alignment to the marked area. Mount the control arm ball joint to the hub assembly.
- Reinstall all others.
- We recommend getting an alignment after installing the new control arms.
If you have any questions or need assistance, please contact us via eBay message or Amazon tools. You can also email us at speed@nbgoldenlion.com. We are always here to help!
Installation Instructions
This control arms # 293062 fit the following vehicle 2001-2010 Chevrolet Silverado 2500HD/3500HD 2001-2010 Sierra 2500HD/3500HD
- Use a floor jack to raise the front of the vehicle, and place jack stands under the frame Finish removing the lug nuts and wheel.
- Disconnect ABS and brake line mounting brackets from Upper Control Arms and spindles.
- Mark the control arm position. Before loosening any of nuts, you need to mark off the control arm’s position.
- Loosen the upper ball joint nuts until there is a visible gap between the nut and spindle.
- Using a hammer, hit the side of the knuckle attached to the upper control arm’s ball joint. Continue hitting the knuckle until the ball joint has been freed.
- Loosen the control arm nuts on both sides.
- Remove old Control arms and then install new control arms. Adjust the control arm alignment to the marked area. Mount the control arm ball joint to the hub assembly.
- Reinstall all others.
- We recommend that align after installing.
Warranty of the ball joints and bushings
We support once chance to exchange parts for free within 1 year if the control
arms go wrong. If you have any questions ,be feel free to contact us.
Thank you for the purchases!
It is our honor to help you. It is our honor to help you. So please write us
about what you think and what you need. We will reply you ASAP and try our
best to help you solve the problem. Please feel free to contact us via eBay
message or Amazon tools. E-mail:
speed@nbgoldenlion.com
Amazon
- Visit www.amazon.com/your-orders
- Find your product
- Click on “contact seller”
- Include your order #
eBay
- Visit www.ebay.com
- Click on ”My eBay”
- Find your product
- Click on “More actions”
- Click on “Contact seller”
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>