Hasbro F7376 Nerf Elite 2.0 Stormcharge Motorized Blaster Instruction Manual
- June 10, 2024
- Hasbro
Table of Contents
Hasbro F7376 Nerf Elite 2.0 Stormcharge Motorized Blaster Instruction
Manual
Product Overview
TO AVOID EYE INJURY:
WARNING: Do not aim at eyes or face. Use of eyewear recommended for players and people within range. Use only official NERF darts. Other darts may not meet safety standards. Do not modify darts or blaster.
CLEARING A JAM
-
Remove clip.
-
Slide open access door.
-
Remove any jammed darts
-
Close door.
NOTE: Access door must be fully closed for blaster to fire.
STORING YOUR BLASTER
For best performance, do not store darts in clip or blaster.
Ask a parent before going online.
Hey NERF Nation! Join us online and keep up with the latest and greatest NERF news!
CAUTION: Do not aim or shoot at eyes or face of people or animals. Use only the projectiles designed for this product. Do not modify projectiles or projectile blaster.
NERF and HASBRO and all related trademarks and logos are trademarks of Hasbro, Inc.© 2023 Hasbro. Hasbro, Pawtucket, RI 02861-1059 USA. HASBRO CANADA, LONGUEUIL, QC, CANADA J4G 1G2. US/CANADA TEL. 1-800-255-5516. Importado por:
Assembly
ACCESS DOOR
Must be fully closed for blaster to fire
IMPORTANT: BATTERY INFORMATION
Retain this information for future reference. Batteries should be replaced by
an adult.
CAUTION:
TO AVOID BATTERY LEAKAGE
- Always follow the instructions carefully. Use only batteries specified and be sure to insert them correctly by matching the + and – polarity markings.
- Do not mix old batteries and new batteries or standard (carbon-zinc) with alkaline batteries.
- Remove exhausted or dead batteries from the product.
- Remove batteries if product is not to be played with for a long time.
- Do not short-circuit the supply terminals.
- RECHARGEABLE BATTERIES: Do not mix these with any other types of batteries. Always remove from the product before recharging. Recharge batteries under adult supervision. DO NOT RECHARGE OTHER TYPES OF BATTERIES.
Should this product cause, or be affected by, local electrical interference, move it away from other electrical equipment. Reset (switching off and back on again or removing and re-inserting batteries) if necessary
LOAD
-
Press tab and remove clip from blaster.
-
Insert darts into clip
-
Insert clip into blaster.
FIRE
Hold down acceleration button, and pull trigger to fire 1 dart.
BARREL
-
REMOVE
-
ATTACH
STOCK
-
REMOVE
Pull down both tabs on stock release at the same time.
-
ATTACH
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>