FLEXIHIRE 05412 SOP Floor Sander User Manual

June 4, 2024
FLEXIHIRE

FLEXIHIRE 05412 SOP Floor Sander

PPE Required

FLEXIHIRE 05412 SOP Floor Sander-fig2

General Safety Instructions

  • Complete pre-start checklist
  • Read Manufacturers Operation Manual (www.flexihire.com.au)
  • Report any faults or damage to Flexihire 1300FLEXIHIRE
  • Do not wear loose clothing or jewellery
  • Do not operate equipment near pedestrians or people
  • Do not operate without the appropriate PPE as detailed
  • Do not operate equipment under the influence of drugs or alcohol

General Electricity Safety

  • Ensure all electrical equipment has a current test tag within 3 months
  • Do not operate equipment in or around water or damp environments
  • It is recommended to use a safety switch to power this equipment
  • Ensure the power lead is well stowed and do not present trip hazards
  • Isolate the power by removing the plug prior to performing any work on the equipment including prior to changing leads or tools or bits

Risk Assessment

  • Assess the immediate work area for any hazards
  • Control or eliminate all the risks associated with the hazards
  •  Hazards to check for that may require risk control-
    • Overhead power lines
    • Digging
    • Confined space
    • Traffic & moving machinery
    • Stored energy – air, hydraulic, electricity, pressure
    • Working at height
    • Falling objects
    • High Voltage
    • Any stored energy

Operating Safety Instructions

Operators should familiarise themselves with the equipment| Only qualified personnel to perform maintenance and repairs
---|---
Never operate faulty equipment| Check that the power cord does not create a trip hazard
Always turn off tools and disconnect from the power prior to making any tool/blade changes or lead connections| Do not block airflow to machine as it can cause overheating
Do not operate under the influence of drugs or alcohol| Do not use power tools in or near water
Power tools can be very powerful beware of;

• Strong forces on start up

• Very high speeds

• Blades & bits can catch and cause them to kick violently

• Debris being ejected from the work piece

| Before starting ensure to;

• Position feet and body in a wide stance

• Hold the tool firmly with both hands

• Plan your cut or work prior to starting

• Ensure the work piece is well secured

Ensure belts and pieces are tightly secured and not worn. Always disconnect from the power supply when changing belts and pads| During operation;

• Do not apply excessive force let the tool do most of the work

• If you need to apply more force the belt could worn

• Ensure you can not distracted

Do not use power tools in or near water| Be careful not to overheat the work piece which could lead to worn out tools
Do not operate unless the guards are in place| Clean up the area after use and coil the lead up
Move the sander around evenly and do not leave in one place| Keep both hands firmly on the sander
BEWARE – Never leave equipment unattended with a full dust bag immediately after use. Ignition can occur from heat and start a fire|

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals