LongPlus AIBIRCARE BirdCare Feeder Camera User Guide
- June 10, 2024
- LongPlus
Table of Contents
LongPlus AIBIRCARE BirdCare Feeder Camera User Guide
Warning
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
The antennas used for this transmitter must be installed to provide a
separation distance of at least 20cm from all persons and must not be co-
located for operating in conjunction with any other antenna or transmitter.
FCC (USA) 15.9 prohibition against eavesdropping except for the operations of
law enforcement officers conducted under lawful authority, no person shall
use, either directly or indirectly, a device operated pursuant to the
provision of this part for the purpose of overhearing or recording the private
conversations of other unless such use is authorized by all of the parties
engaging in the conversation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
IC Caution:
– English: This device contains licence-exempt transmitter(s)/ receiver(s)
that comply with Innovation, Science and Economic Development Canada’s
licence-exempt RSS(s). Operation is subject to the following two conditions:
This device may not cause interference.
This device must accept any interference, including interference that may
cause undesired operation of the device.
CE RED This product can be used across EU member states.
What’s In The Box
Camera Structure
Insert Micro SD Card
BirdCare Cam comes with a built-in card slot which supports up to 128GB Micro
SD card.
Step 1: Rotate the camera down to the bottom.
Step 2: Open the top silicone plug. Insert the Micro SD card. Make sure
to plug it in the right direction.
Step 3: Finally, Cover silicone plug.
Assemble BirdCare Feeder Cam
Assemble the roof
Step 1: Face up the side of the roof with the buckles. Align the small
pillar on both the left and the right side with the buckles of the white bird
seed container.
Step 2: Push down to insert.
Step 3: Then rotate back to install the buckle behind the white bird seed
container.
Assemble Perch
Use the provided perch screw to install the perch.
Battery Charging
The batteries inside the camera are not fully charged according to the transportation safety regulations. Please fully charge the camera before using it. Please charge the batteries with provided Type C Port Cable (DC5V /1.5A adapter not included).d The status light will be in solid yellow when charging, and will turn to solid green when it is fully charged. It takes about 14 hours to fully charge your camera.
How To Turn On & Off The Camera
To turn on the camera:
Long press the power button for 3s to turn on the camera. Then the Status
Light in the front of the camera will be solid blue. Double click the power
button to enter WiFi mode after the prompt tone.
To turn off the camera:
Long press the power button for 3s to turn off the camera. Then the Status
Light in the front of the camera will be off.
Read Before Installation
- Keep BirdCare Feeder Cam and all accessories out of reach of children and pets. d
- Make sure the camera has been fully charged (DC5V /1.5A).
- Working temperature: -10°C to 50°C (14°F to 122°F) Working relative humidity: 0-95%
- Please do not expose the camera lens to direct sunlight.
- The camera has an IP65 waterproof rating, which supports working properly under rains or snows. But it can not be soaked in water.
Note:
- BirdCare Feeder Cam only works with 2.4GHz Wi-Fi.
- Strong lights may interfere with the device’s ability to scan QR code.
- Avoid placing the device behind furniture or near microwaves products. Try to keep it within range of your Wi-Fi signal.
Set Up With Longplus App
https://www.ali- luya.com/home/account/app-q-rcode?p_id=7&name=longplus
Download Longplus App from App Store or Google Play. Follow the in-app instruction to complete the entire set up process.
Installation
Check the following things before you drill holes on your wall:
BirdCare Feeder Cam has been successfully added to your Longplus App and is
able to stream video.
Wall Installation:
Step 1:
- Use the provided drilling template to mark the position of holes on your wall. Use drill bit(5/16,8mm) to drill two holes.
- Install the anchors to fix the screws.(install on wood skip this step.)
- Install the Mounting Bracket on your wall with the screws provided.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>