SK-939Tx-GxQ1 Single Channel RF Transmitter
Instruction Manual

SK-939Tx-GxQ1 Single Channel RF Transmitter

• Frequency 433.92MHz
• Operates up to 500f (150m)
• Over 68 billion (6.810″) possible codes
• LED transmission indicator
• Includes one 3VDC lithium battery (CR-2032)
• Compact size
• Compatible with all SECO-LARM SK-series receivers of the same frequency
• Also available without logo ­SK-939T1-GBUQ1 -433.92MHz

Actual range will vary depending on the installation and operating environment

Dimensions

Specifications

Model| SK-939T4-GNUQl
SK-939T4-GNQ1| SK-939T3-GNUQI
SK-93913-GNQI| SK-93912-GNUQ1
SK-939T2-GNQ1| SK-939T1-6BUO
SK-939T1-0BQT
---|---|---|---|---
Power| 30G batter (GR.-2032, included
RF Frequency| 433 92MHz

of Buttons| 1| 2| 3| 4

Channels| 1| 1| 1| 1
IP Rating| IP 68Waterproof
Possible codes| Over 68 billion (6.8101
Dimensions| 1 ¼ Χ 2 3/16 Χ 5/16 (31.5 Χ 55 Χ 8 mm)

California Proposition 65 Warning: These products may contain chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.

WARRANTY:

This SECO-LARM product is warranted against defects in material and workmanship while used in normal service for one (1) year from the date of sale to the original customer. SECO-LARM’s obligation is limited to the repair or replacement of any defective part if the unit is returned, transportation prepaid, to SECO-LARM. This Warranty is void if damage is caused by or attributed to ads of God, physical or electrical misuse or abuse, neglect, repair or alteration, improper or abnormal usage, or faulty installation, or if for any other reason SECO-LARM determines that such equipment is not operating properly as a result of causes other than defects in material and workmanship. The sole obligation of SECO-LARM and the purchaser’s exclusive remedy, shall be limited to the replacement or repair only, at SECO-LARM’s option. In no event shall SECO-LARM be liable for any special, collateral, incidental, or consequential personal or property damage of any kind to the purchaser or anyone else.
NOTICE: The SECO-LARM policy is one of continual development and improvement. For that reason, SECO-LARM reserves the right to change specifications without notice. SECO-LARM is also not responsible for misprints. All trade marks are the property of SECO-LARM U.S.A., Inc. or their respective owners. Copyright 2023 SECO-LARM U.S.A., Inc. All rights reserved.

FCC IC COMPLIANCE STATEMENT

FCC ID: K4E919T4G-1
IC ID: 23770-K919T4GNIUQ1
This device complies with FCC Rules Part 15. Operation is subject to the following two conditions:

• This device may not cause harmful interference.
• This device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the Federal Communications Commission (FCC) rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment causes harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by doing one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user ‘s authority to operate the equipment.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure compliance. To maintain compliance with FCC exposure compliance requirement, please follow operation instruction as documented in this manual.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’ s licence-exempt RSS(s). Operation is subject to the following two conditions:

1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation of the device.

This equipment complies with [SED radiation exposure limits set forth for an uncontrolled environment. The device has been evaluated to meet general RF exposure requirement.

SECO-LARM® U.S.A., Inc.
16842 Millikan Avenue, Irvine, CA 92606
Phone: 949-261-2999 I 800-662-0800
Website: www.seco-larm.com
Email: sales@seco-larm.com
® PITSE1
MI_SK-939T1-GxQ 230314 docx

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>