MEILAN C5 Heart Rate Monitor User Manual

June 10, 2024
MEILAN

MEILAN-logo

MEILAN C5 Heart Rate Monitor

MEILAN-C5-Heart-Rate-Monitor-product-img

Product Information

The product complies with part 15 of the FCC rules and has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction. Any changes or modifications not expressly approved could void the user’s authority to operate the equipment.

Product Usage Instructions

When using the product, please ensure that it does not cause harmful interference to any other devices. Additionally, the product must accept any interference received, including interference that may cause undesired operation. Please do not make any changes or modifications to the product without express approval as this could void your authority to operate the equipment.

HOW TO WEAR C5

Note: Please remove the battery insulator sheet before using the heart rate sensor.

MEILAN-C5-Heart-Rate-Monitor-fig-1

  1. Snap the sensor into the strap.
  2. Adjust the strap to fit on your chest snugly, but comfortably.
  3. Moisten the contact points on the back of the strap with water (a little) or electrode gel to improve conductivity.
  4. Wrapthelooseendofthe strap around your chest and snap it into place.
  5. Make sure the electrode area is close to your skin so that the sensor is at the front of your chest.

HR monitor will be activated after properly matching, the LED light will start to flash, then can connect the device with the MEI LAN bike computer or APP; if the HR monitor has not been connected for more than 10 seconds, it will enter the sleep state, need to be reactivated before use.
When the HR monitor is successfully connected by the bike computer or APP, the LED indicator will show steady light; light off after 20 seconds.

Please replace the new battery in the below conditions:

  1. The indicator no light.
  2. HR monitor can’t be searched.
  3. The heart rate value appears intermittent.

FCC STATEMENT

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and the receiver.
  • Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals