NANCE INDUSTRIES 50138 Carpet and Rug ParkPro SAMPLE Multipurpose Installation Guide
- June 10, 2024
- NANCE INDUSTRIES
Table of Contents
NANCEINDUSTRIES 50138 Carpet and Rug ParkPro SAMPLE Multipurpose
INDOOR INSTALLATION
STEP 1
- Make sure your subfloor is flat, level, and free from any dust or debris.
STEP 2
- Next measure your area and map out where the artificial turf will be installed.
STEP 3
- Glue down underlayment or padding to increase the longevity of your new indoor turf area.
STEP 4
- Once your underlayment or padding is installed you will then glue down your artificial furf grass.
STEP 5
- Allow for ample time (15-30 minutes) for the adhesive to air dry before laying the artificial turf
STEP 6
- Take your time and move slowly when making cuts (only from the back) during the installation process, make sure to keep the turf blades going in the same direction when installing.
STEP 7
- After you have glued down the artificial turf, use a weighted roller to roll the newly turfed area. This added step will help insure that your new artificial turf installation is properly glued down and adhered to the subfloor.
STEP 8
The last step (OPTIONAL) is to add the turf fill
- a. Use a large brush broom to make the turf blades stand up.
- b. Apply the turf fill, using a drop spreader, to the brushed turf area.
- c. Make sure to spread the fill evenly as possibl across the brushed turf area
- d. Once the fill has been spread evenly, brush it in lightly to create a finished look.
- e. The artificial turf grass blades should be standing straight up with turf fill underneath
OUTDOOR INSTALLATION
STEP 1
- Make sure your area is flat and has been graded to level.
STEP 2
- Next measure your area and map out where the artificial turf will be installed.
STEP 3
- Once you have a proper substrate (concrete, rock bed, or sand you are ready for installation.
STEP 4
- Take your time and move slowly when making cuts (only from the back) during the installation process, make sure to keep the turf blades going in the same direction when installing
STEP 5
- Use a weighted roller as you are installing the turf down to your substrate. This will help prevent bunching or creases.
STEP 6
Add the turf fill.
- a. Use a large brush broom to make the turf blades stand up.
- b. Apply the turf fill, using a drop spreader, to the brushed turf area.
- c. Make sure to spread the fill evenly as possible across the brushed turf area.
- d. Once the fill has been spread evenly, brush it in lightly to create a finished look.
- e. The artificial turf grass blades should be standing straight up with turf fill underneath
Warranty
Limited Lifetime Warranty
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>