BELL B5001175 Grid Helmet Light USB Rechargeable User Guide
- June 11, 2024
- Bell
Table of Contents
BELL B5001175 Grid Helmet Light USB Rechargeable
QUICK START
- Push button to power on.
- Click to cycle modes.
- Hold 1 second to power off, light powers back on in the last mode used.
FUEL GAUGE
Color LEDs in the power button help you monitor your light battery power, to
tell you when it’s time to charge your light once more.
USB CHARGING
MAKE SURE TO FULLY CHARGE LIGHT BEFORE FIRST USE.
The light indicator will blink when charging.
When charging is complete the light indicator will be a steady green.
| MODES | LUMENS | RUNTIME | AUTO-ECO |
|---|---|---|---|
| Solid | 30 | 1.5h | – |
| Pulse | 20 | 3h | +1h |
| Strobe | 15 | 6h | +1h |
| Eco | 15 | 15h | – |
COMPATIBILITY
This light is compatible with the Bell Falcon'” XRand Falcon™ XRVhelmets. It is not designed to pair with any other helmet make or model.
TO ATTACH TO HELMET
Insert bottom bracket of light into slot at the bottom of the rear helmet
vent, as shown in Figure A. Push top of light into vent until it clicks into
place.
TO REMOVE FROM HELMET
Inside the helmet, locate the sliding lever on the back of the light, as shown
in figure 8.
Slide the lever down towards the bottom of the helmet and push out until the
light pops
out of the back vent.
INCLUDED:
(1) Li Po Battery, (1) USB charging cable
WARNING: Potential choking hazard ta children. This light is extremely bright-do not aim directly into eyes. UK ONLY: When used far cycling, this light should be used in conjunction with a British Standard 6102/3 cycle light & WARNING: This product can expose you ta Bisphenal A (BPA), which is known ta the State of Califamia ta cause reproductive harm. Far mare information, go ta www.P65Wamings.ca.gav
FCC Statement This equipment has been tested and found ta comply with the
limits far a Class B digital device, pursuant ta Part 15 of the FCC Rules.
These limits are designed ta provide reasonable protection
against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful
interference ta radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference ta radio or television reception,
which can be determined by fuming the equipment off and an, the user is
encouraged ta try ta correct the interference by one or mare of the fallowing
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet an a circuit different from that ta which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician far help. Shielded interface cable must be used with the equipment in order to comply with the limits far a digital device pursuant ta Subpart 8 of Part 15 of FCC Rules. Specifications and designs are subject ta change without any notice or obligation an the part of the manufacturer.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>