Hubbell-Bell PRCF57550GY Ceiling Fan Electrical Box Instruction Manual
- May 15, 2024
- Hubbell-Bell
Table of Contents
INSTRUCTIONS
Outdoor Ceiling Fan
and Light Fixture Box
PRCF57550GY Ceiling Fan Electrical Box
CAUTION: TURN OFF POWER BEFORE INSTALLATION
Install in accordance with national and local electrical codes.
- Mount box to structural member by partially driving the (2) included lag bolts through the base of the electrical box. Alternate tightening the bolts back and forth until they snug up evenly. This prevents the bracket from twisting which may cause alignment issues. The box is designed to mount to the narrow side of standard framing lumber. Note – Use markings on backside of box to orient for the desired conduit entry (see Fig. 1). Tick marks are also shown inside of box.
- Install appropriate fittings and conduit and pull power supply wires into box. If applicable use reducer bushings to change from 3/4 to 1/2″. Close all unused holes with closure plugs. Seal all openings to comply with wet location installation.
- Use rain collar when fixture opening exceeds electrical box opening, Attach rain collar using the included (2) #6-32 flat head screws.
- Attach fixture/bracket to the box using the hardware included with this kit. Note – the #10-32 screws must be used for all light fixtures heavier than 50lbs, and all ceiling fans. For wet locations, use outdoor rated ceiling fans and lights only.
- Connect ground wire(s) to green ground screw inside electrical box. Complete fixture/fan wiring and installation following the manufacturer’s instructions. Max. Rating: Ceiling fan – 70lbs, Light fixtures – 150 Lbs.
- Tum power back on and check fan or fixture for functionality.
IMPORTANT: To ensure long term safety, it is important to balance fans as required. Follow manufacturer’s instructions.
REVISIONS
REV.| DATE| DESCRIPTION| BY:
–| 2/19/2020| INITIAL RELEASE| TCY
| GROUND SCREW | STEEL | GREEN |
|---|---|---|
| LAG SCREW | STEEL | – |
| MACHINE SCREW | STEEL | – |
| SCREW | STEEL | GALVANIZED |
| PLUG, 3/4″ | PVC | GRAY |
| REDUCER, 3/4″-1/2″ | PVC | GRAY |
| RAIN CANOPY | POLY- CARBONATE | GRAY |
| WP CEILING FAN BOX | PVC, STEEL | GRAY |
| DESCRIPTION | MATERIAL | FINISH |
LIST OF PARTS
THE DESIGN AND DIMENSIONS OF THE PRODUCT SHOWN ON THIS DRAWING ARE SUBJECT TO
CHANGE WITHOUT NOTICE
TITLE:
WEATHERPROOF ROUND BOX, CEILING FAN RATED, W/ DRAWN STEEL BRACKET, GRAY
TOLERANCE UNLESS OTHERWISE SPECIFIED
.XX DECIMAL ± .015
.XXX DECIMAL ± .005
ANGLE ± 2º|
---|---
DRAWN BY:| TCY| SCALE:
1:4
APP. BY:| N.S.
DATE:| 2/19/2020
FILE NO.: PRCF57550GY CUS
DIMENSION SHEET FOR CAT. NO.
PRCF57550GY
SIZE: A
HUBBELL COMMERCIAL CONSTRUCTION
A Division of Hubbell Incorporated (Delaware)
480-921-7552
www.hubbell.com/bell/en
Documents / Resources
|
Hubbell-Bell PRCF57550GY Ceiling Fan Electrical
Box
[pdf] Instruction Manual
PRCF57550GY Ceiling Fan Electrical Box, PRCF57550GY, Ceiling Fan Electrical
Box, Electrical Box
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>