SAP Printable Strips Clawgs Sizing Guide User Guide

: June 11, 2024
: SAP

Table of Contents

SAP Printable Strips Clawgs Sizing Guide
Product Information
Product Usage Instructions
SETUP
- SIZE SELECTION
Printable Strips Clawgs Sizing Guide
Documents / Resources

SAP Printable Strips Clawgs Sizing Guide

Product Information

Clawgs is a product that provides protection to dogs’ paws. It is a sizing guide that helps pet owners determine the correct size of Clawgs for their dogs. The product comes with printable strips that can be cut out and used to measure the size of the dog’s front paw. The sizing guide is available on the website dogsap.com.

Product Usage Instructions

Step One – Setup

Print the sizing strips on LETTER SIZE paper: 8.5 X 11 in ( 216 X 279 mm ).
In print settings, set the Page Sizing & Handling to Actual Size ( 100 % ).
Use measuring tape to check your printer’s scaling.
Use scissors to cut out the sizing strips that may fit your dog.
Have your dog lay on its side.

Step Two – Pressing the Finger Tab and Sizing Strip

Press the finger tab against your dog’s leg behind the metacarpal/metatarsal pad’s (heel pad’s) furthest point from the front claws, which is not centered behind the heel pad. You should be pressing at Clawgs’ heel location, which is the leg’s skinniest part directly behind the heel pad.
Press the sizing strip’s loose end against your dog’s front pads. Make sure your dog’s wrist/ankle is bent as far as possible to its standing position. The sizing strip’s front edge is located at that size`s front claws’ opening.

Size Selection
Select the longest sizing strip that does not contact your dog’s front claws’ tips while your dog’s wrist/ankle is fully bent to its standing position. Ideally, the sizing strip will completely cover your dog’s front pad but will not contact your dog’s front claws’ tips. Note: Your dog’s front paws and back paws may be different sizes. If you can’t decide between two sizes, select the larger size.

Printer Scaling Check
Use this section to check if the printer is printing the sizing guide accurately. The check has a 10cm and 5in scale that can be measured with a ruler or measuring tape.

SETUP

Print the sizing strips on LETTER SIZE paper: 8.5 X 11 in ( 216 X 279 mm ).
In print settings, set the “Page Sizing & Handling” to ”Actual Size” ( 100 % ).
Use measuring tape to check your printer’s scaling.
Use scissors to cut out the sizing strips that may ﬁt your dog.
Have your dog lay on its side.

STEP ONE

Press the ﬁnger tab against your dog’s leg behind the metacarpal / metatarsal pad’s (”heel pads”) furthest point from the front claws, which is not centered behind the heel pad.
You should be pressing at Clawgs’ heel location, which is the leg’s skinniest part directly behind the heel pad.

STEP TWO

Press the sizing strip’s loose end against your dog’s front pads.
Make sure your dog’s wrist/ankle is bent as far as possible to its standing position.
The sizing strip’s front edge is located at that size‘s front claws’ opening.

SIZE SELECTION

Select the longest sizing strip that does not contact your dog’s front claws’ tips while your dog’s wrist / ankle is fully bent to its standing position.
Id ally, the sizing strip will completely cover your dog’s front pad but will not contact your dog’s front

Note:

Note: Your dog’s front paws and back paw s may be different sizes.
Note: If you can’t decide between two siz es, select the larger size.

Printable Strips Clawgs Sizing Guide

IMPORTANT:

Hold ﬁnger tab against the leg behind the heel pad’s furthest point from front claws, which is off center.
Fully bend the wrist/ankle to its ‘standing position’

www.dogsap.com