dog Sap CLAWGS Sizing Guides and Demonstration Videos User Guide
- June 11, 2024
- dog Sap
Table of Contents
dog Sap CLAWGS Sizing Guides and Demonstration Videos
Product Information
Clawgs Sizing Guide
Clawgs are protective boots for dogs’ paws that prevent injuries and provide comfort during outdoor activities. The Clawgs Sizing Guide is a printable strip that helps determine the right size for your dog.
The sizing guide is available on dogsap.com and can be printed on legal-size paper (8.5 x 14 in or 216 x 356 mm).
Setup
Before using the Clawgs Sizing Guide, follow these steps:
- Set the print settings to the Actual Size (100%)
- Use measuring tape to check your printer’s scaling
- Cut out the sizing strips that may fit your dog
Product Usage Instructions
Step One: Finger Tab
Press the finger tab against your dog’s leg behind the heel pad’s furthest point from the front claws, which is not centered behind the heel pad. You should be pressing at Clawgs’ heel location, which is the leg’s skinniest part directly behind the heel pad.
Step Two: Front Pad
Press the sizing strip’s loose end against your dog’s front pads. Make sure your dog’s wrist/ankle is bent as far as possible to its standing position. The sizing strip’s front edge is located at that size`s front claws’ opening.
Size Selection
Select the longest sizing strip that does not contact your dog’s front claws’
tips while your dog’s wrist/ankle is fully bent to its standing position.
Ideally, the sizing strip will completely cover your dog’s front pad but will
not contact your dog’s front claws’ tips.
Note: Your dog’s front paws and back paws may be different sizes. If you
can’t decide between two sizes, select the larger size.
Printer Scaling Check
Use the 10 cm or 5 in ruler on the sizing guide to check your printer’s scaling before printing the sizing strips.
INSTALLATION INSTRUCTION
SETUP
- Print the sizing strips on LEGAL SIZE paper: 8.5 X 14 in ( 216 X 356 mm ).
- In print settings, set the “Page Sizing & Handling” to ”Actual Size” ( 100 % ).
- Use measuring tape to check your printer’s scaling.
- Use scissors to cut out the sizing strips that may fit your dog.
- Have your dog lay on its side.
STEP ONE
- Press the finger tab against your dog’s leg behind the metacarpal / metatarsal pad’s (”heel pads”) furthest point from the front claws, which is not centered behind the heel pad.
- You should be pressing at Clawgs’ heel location, which is the leg’s skinniest part directly behind the heel pad.
STEP TWO
- Press the sizing strip’s loose end against your dog’s front pads.
- Make sure your dog’s wrist/ankle is bent as far as possible to its standing position.
- The sizing strip’s front edge is located at that size‘s front claws’ opening
SIZE SELECTION
- Select the longest sizing strip that does not contact your dog’s front claws’ tips while your dog’s wrist / ankle is fully bent to its standing position.
- Ideally, the sizing strip will completely cover your dog’s front pad but will not contact your dog’s front claws’ tips.
- Note: Your dog’s front paws and back paws may be different sizes.
- Note: If you can’t decide between two sizes, select the larger size.
Dimension
IMPORTANT:
- Hold the finger tab against the leg behind the heel pad’s furthest point from the front claws, which is off-center.
- Fully bend the wrist/ankle to its ‘standing position’ dogsap.com
Documents / Resources
| dog
Sap CLAWGS Sizing Guides and Demonstration
Videos
[pdf] User Guide
CLAWGS Sizing Guides and Demonstration Videos, CLAWGS Sizing, Guides and
Demonstration Videos, and Demonstration Videos, Demonstration Videos
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>