Tekelek LPG Logger 4G NB-IoT LPG Tank Monitor Installation Guide
- October 30, 2023
- Tekelek
Table of Contents
Tekelek LPG Logger 4G NB-IoT LPG Tank Monitor Installation Guide
Thank you for purchasing the Tekelek LPG Logger 4G NB-IoT/CAT-M1 which is an ATEX certified multipurpose data logger which communicates data to a remote server, suitable for monitoring fuel tanks levels and flow rates.
Safety Information:
The LPG Logger is ATEX compliant, but if installing in a harsh, environment first check local applicable regulatory and safety guidelines to ensure installer security. Please refer to the User Manual for more information on the warnings and hazards.
Installation
The LPG Logger works in conjunction with a remote server and before installation must first be registered to this. Access to the backend server is required to verify that the unit has correctly joined the network. The following outlines the LPG Logger mounting options.
-
Adhesive Strips – Horizontal mounts:
-
Cable Ties – Handle mount:
-
Cable Ties – Horizontal mount onto pipe:
-
Cable Ties – Vertical mount onto pipe:
-
Screws – Wall mount:
-
Screws – Wall mounted from the rear:
Activation
Hold the supplied magnet to the indicated hot spot on the LPG Logger, 4 short beeps will be heard approx. one second apart, these will be followed be a long beep which indicates that the logger has been activated and will now attempt to connect to the network.
- A series of beeps will be heard. This indicates the logger is registering onto the network.
- Upon successful registration to the network the logger will attempt to initiate a connection to the server, details of which have been preconfigured in the logger. This is indicated by higher pitched beeping.
- The successful activation of the unit is indicated by two successive short beeps two seconds apart. Once the logger has successfully connected, the server must issue the required commands to the logger to complete the activation process.
Beep Pattern
| Beep Pattern | Definition |
|---|---|
| Low beep once per second | Network Registration |
| High beep once per second | Network Registration |
| Low beep once every 4 seconds | Network / TCP Listen |
| Low beep once every 2 seconds | Re-establish Network / TCP |
| High / Low combination beep | Incoming Data |
| Low / High combination beep | Outgoing Data |
| Low double-beep every 4 seconds | Network Listen |
(Data Received & Unit Active)
Low double-beep every 2 seconds| Re-establish Network
High double-beep every 4 seconds| TCP Listen
(Data Received & Unit Active)
High double-beep every 2 second| Re-establish TCP
Fitting gauge
-
Where applicable, remove existing gauge from the LPG tank by loosening and removing the screws holding the gauge in position.
-
Place the new gauge of the LPG Logger onto the LPG tank and secure with screws.
For more information on the Tekelek LPG Logger 4G NB-IoT/CAT-M1 please visit our website www.tekelek.ie where a link to our YouTube page can also be found.
References
- Tekelek | Tank Level Monitoring, Engineering, Design, Liquid
- Tekelek | Tank Level Monitoring, Engineering, Design, Liquid
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>