amazonbasics B084QRGKFT Slim Robot Vacuum Cleaner User Manual

amazonbasics B084QRGKFT Slim Robot Vacuum Cleaner User Manual

Contents

Before getting started, ensure the package contains contains the following components:

Product Overview

1. Flip cover
2. Bumper
3. Dust container
4. DC socket
5. Air vents
6. Onion button
7. Charging contacts
8. DC socket
9. IR transmitter (front)
10. IR transmitter (top)
11. Power LED
12. Primary filter
13. NEPA fitter
14. Fitter holder
15. Front sensors
16. Charging contacts
17. Brush holder
18. Suction inlet
19. Lateral sensors
20. On/off switch

IMPORTANT SAFEGUARDS

 Read these instructions carefully and retain them for future use. If this product is passed to a third party, then these instructions must be included.

When using electrical appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and/or injury to persons including the following:

• Read all instructions.
• Only use this product for its intended use.
• This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
• Children shall not play with the appliance.
• Cleaning and user maintenance shall not be made by childrer without supervision.
• The appliance is only to be used with the power adapter provided with the appliance.
• The appliance is only to be used with the charging dock provided with the appliance.
• Examine the power supply unit regularly for damage, especially the cord, plug and enclosure. If the power supply unit is damaged, it must not be used.
• Keep the product away from any heat source, radiation. The product must not vacuum the following objects:
  • All liquids such as water and solvents;
  • Construction dust and garbage such as lime and cement; – Hot objects, such as cigarette butts still burning;
  • Sharp fragments, such as glass;
  • Flammable and explosive materials, such as gasoline or alcohol.
• Do not immerse the product in water.
• Before using the product, remove all fragile items (such as glasses, lamps, etc.) and items that may wrap around the brushes and wheels (such as wires, curtains, etc.) from the floor.
• Before using the product, secure all potentially dangerous areas and objects (e.g. staircases, lamps, burning candles etc.).
• The product may not work properly under strong light.
• Do not place any objects on the product.
• Do not use this product in areas where people may unintentionally cross the product’s path and get hurt (e.g. care facilities, kindergarten).
• Secure the area to be cleaned against all other possible sources of danger (e.g. pets).
• Never use the product without its dust container.
• Never short-circuit the charging contacts. Avoid contact with metal objects.
• This product complies with protection class II. It has reinforced insulation and therefore does not need to be connected to earth.
• This product is intended for indoor use only.

Warnings For The Built-in Battery

• The built-in battery is non-replaceable.
• Do not throw the product into a ire.
• Do not leave the battery charging for a prolonged period of time when the product is not in use. Do not charge overnight.
• If the product appears to be bulging or shows other undesirable phenomena (e.g. excessive noise), stop using it immediately
• Do not cover while charging. Charge in a well-ventilated area.
• Charge the product once every 3 months.
• Batteries produce heat when charging and discharging. If the product becomes too hot to touch, turn it off and unplug it immediately
• If the battery leaks, avoid contact with skin and eyes. Rinse affected areas immediately with plenty of clean water, then consult a doctor.

Intended Use

• This product is intended for automated vacuum cleaning of household areas with normal level of did. It is suitable for hard floors and short-pile carpets.

• This product is intended for household use only It is not intended for commercial use.

• No liability will be accepted for damages resulting from improper use or non-compliance with these instructions.
  Before First Use

• Remove any protective film.

• Check for transport damages.

Risk of suffocation! Keep any packaging materials away from children – these materials area potential source of danger, e.g. suffocation.
Before first charging process, run the product until the battery is empty. This serves to maximize the capacity of the battery

Preparation

Brushes

Push the brushes (C) firmly onto the brush holders (17).

On the brushes and under the brush holders there are matching markings (L = left / R = right). Match the brushes according to the markings.

Charging Dock

• Place the charging dock (B) against a wall. Keep a free space of at least 1 metres to the sides and 2 metres at the fruit.
• Tie excess cable of the power adapter (E) together.
• Connect the power adapter to the charging dock.
• Connect the power adapter to the mains socket. The power LED (11) lights up.

Remote Control

• Open the cover at the back of the remote control (F).
• Insert 2 AAA batteries (not provided) into tha battery compartment. Heed the polarity markings in the battery compartment.
• Close the battery compartment cover.
  Replace the batteries as soon as the range decreases noticeably or the product stops responding to remote commands.

Cleaning Area

• Clear the area. Move furniture aside.

• Hide any cables, shoes. etc.
  

• Roll up the edges of carpets with fringes.
  

• Before using the product, secure all potentially dangerous areas and objects (e.g. staircases, lamps, burning candies etc.) against access/contact.
  For example, place a heavy object on the top of the staircase.

Operation

Start/Stop

• Set the on/off switch (20) to | position. The product is in standby mode.

• Place the product on the floor.

• Press the on/off button (6) for 2 seconds. 2 signals sound. The on/off button blinks slowly in blue. The product is in ready-to-work mode.
  In ready-to-work mode, you can control the product with the remote control (F).
  After 1 minute in ready-to-work mode the product switches automatically to standby mode. After the product entered standby mode, you can turn il on for the next 15 minutes with the remote control.

• To start the product: Push the on/off buttor (on housing or remote control).
  3 signals sound. The on/off button lights steadily in blue,

• To Set the product to ready-to-work mode: Push the on/off button (on housing ‘oF remote contro!) 1 signal sounds. The on/off button blinks slowly in blue.

• To set the product to standby mode:

  • Set the product to ready-to-work mode (ff not already done).
  • Push the on/off button (on housing) for 2 seconds. 1 signal sounds. The on/off ‘button goes out.
    After the product entered standby mode, you can tum it on for the next 15 minutes with the remote control.

• To switch off the product:

  • Set the product to standby mode.
  • Set the or not switch to O position.

Remote Control

Cleaning Modes

• Press to change the cleaning mode.
  When you set the product to ready-to-work mode, this setting stays active. After restarting the cleaning process, the product continues with the previous set cleaning mode.

Power Mode

• Press to start the power mode.
• The product cleans in a circular motion with increased suction power.
• The power mode ends automatically after approx 25 seconds, The previous cleaning mode continues.

Charging

Set the on/off switch (20) on the bottom to I position before charging.

For the best battery performance, begin the charging process when the batter is fat. Aways fly charge the battery.

There are 2 options to charge the product.

Option A: Direct Charging

• Connect the power adapter (E) to the power supply socket (4) of the product.
• Connect the power adapter to the mains socket.

option 8: Charging Dock

• Connect the power adapter (E) to the power supply socket (8) of the charging dock (8).
• Connect the power adapter to the mains socket.
• The product will automatically return to the charging dock once its batteries become empty.
• For sending the product manually to the charging dock, press

Indicators

• While charging, the on/off button flashes slowly in red.
• When the charging process is finished, 5 signals sound. The on/off button lights up steadily in blue.

After the charging process, the product enters the standby mode.

Cleaning and Maintenance

Switch the product of before cleaning.
Disconnect the product from the power supply before cleaning.
Do not immerse the electrical parts of the product in water or other liquids. Never hold the product under running water.

Housing

• For cleaning all housings and the suction channel: Wipe with a soft, sightly moist cloth,

• Dry the product after cleaning.

• Never use corrosive detergents, wie brushes, abrasive scourers, metal or sharp utensils to clean the product.

• Cean the brushes with another brush or a vacuum cleaner.

• Remove wrapped threads etc. from the brushes and wheels by hand.
  

• Regularly wipe the sensors (15, 19), wheels, charging contacts (7, 16) and transmitters (9, 10) with a soft, dry cloth,

Dust Container and Filter

Empty the dust container (3) after each use.
Clean the filters (12, 13) after using for 15-20 days.

• Press on the flip cover (1) to open it.

• Remove the dust container (3)
  

• Remove the HEPA filter (13),

• Open the dust container (3)

• Remove the primary filter (12)

• Pour the dust into a litter bin,
  

• Rinse the dust container (3) and primary filter (12) with water.

• Clean the HEPA filter (13) with a brush.

• Reassemble the dust container.

• Replace the dust container into the product.

Maintenance

• The maximum life-span of the HEPA filter (13) is 24 months. Replace it after its life-span.
• Replace the brushes (C) if they are worn, Remove them by pulling them down from the brush holders (17). If necessary, you can lever them up with a flat screwdriver.
• Recharge the battery at least every 3 months.

Troubleshooting

During work, the product stops suddenly. The on/ off button (6) lights up steadily blue.| The product is suspended (sensor (- 5, 19) detects continuous falling hazard or a wheel is floating).| Re-position the product back to the ground and restart it.
The on/off button was pressed. The on/off button lights up steadily blue (the product is not Connected to the charging dock or adapter).| Sensor (15, 19) failure or wheel suspension switch failure.| Clean the sensors (15, 19). If it still does not restore, contact your dealer.
The product does not change direction when it hits an obstacle.| Bumper (2) sensor error.| Check the sensitivity of the bumper (2). and whether there is a foreign object in the bumper.
While charging, the on/ off button flashes quickly h red, accompanied by a buzzer sound.| The on/off switch (20) is in O position| Set the on/off switch (20) to I position.
The on/off button flashes| The battery voltage is too low.| Charge the product.
The on/off button flashes 1 x in blue. lx in red.| One of the brushes (C) is Jammed.| Carefully remove the
brush and reinstall
The on/off button flashes ‘Ix in blue, 2): in red.| The bumper (2) is not flexible.| Loosen the bottom screws of the bumper
The on/off button flashes lx in blue. 3x in red.| A wheel is blocked| Remove the object which is blocking the wheel.

Disposal

The Waste Electrical and Electronic Equipment (WEEE) Directive aims to minimise the impact of electrical and electronic goods on the environment, by increasing re-use and recycling and by reducing the amount of WEEE going to landfill. The symbol on this pr duct or its packaging signifies that this product must be disposed separatety from ordinary household wastes at its end of life. Be aware that this is your responsibility to dispose of electronic equipment at recycling centers in order to conserve natural resources. Each country should have its collection centers for electrical and electronic equipment recycling. For information about your recycling drop off area, please contact your related electrical and electronic equipment waste management authority, your local city office, or your house hold waste disposal service.

Specifications

Main Unit

Input: 24 V 0.6 A
Dust container capacity: 350 ml
Built-in battery: Ni-MH, 1500 mAh
Charging time: approx. 240 min.
Operating time: approx. 70 min.
Cleaning area: 90- I 20 rn2 (970-1290 ft,’)
Noise level: approx. 74 dBA
Net weight: approx. 3 kg (6.7 lbs)
Dimensions (0 x H): approx. 300 x 80 mm (11.8 x 3.1 in)

Power Adapter

Input. 100-240 V-, 50/60 Hz
Output: 24 V , 0.6 A
Cable length: 1.5 m (4.9 ft)

Warranty Information

To obtain a copy of the warranty for this product:

 amazon.co.uk/basics-warranty
 +44 (0) 800-279-7234

Feedback and Help

Love it? Hate it? Let us know with a customer review.

AmazonBasics is committed to delivering customer-driven products that live up to your high standards. We encourage you to write a review sharing your experiences with the product.

 amazon.co.uk/review/review-your-purchases#
 amazon.co.uk/gp/help/customer/contact- us

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>