KONE KCEDZS Elevator Module User Manual

KONE KCEDZS Elevator Module User Manual

APPROVALS AND VERSION HISTORY

Compiled by: Chief Design Engineer, Electronics, Kuisma Valkeapää
Checked by: Expert, Electrification, Marko Turkkila
Approved by: Category Manager, Jukka Korpela
Translation approved by: /

Issue| Date| Description of Change| Ref CR| Approved By
---|---|---|---|---
–| 2021-11-24| First issue| |

GENERAL

Device description

KCEDZS is 13.56MHz RFID radio device used for monitoring the location of the elevator car in elevator shaft.

Safety information

No electrical safety information and warnings are needed as the electrical operating voltage of the radio equipment is lower that safety voltage.

To comply with human exposure requirements the equipment must be installed and operated with a minimum distance of 200 mm of the human body.

Power and environmental ratings of the device

KCEDZS is powered by KONE KCE electrification.

• Input voltage: 24VDC (9-32VDC.)
• Input current: Max 180mA
• IP protection class: IP33
• Operation temperature range: -20 – +65 ºC
• Transmitter maximum conducted output power: 100mW (at 13.56 MHz)

INSTALLATION AND USE

KCEDZS will be installed and used in restricted access area (elevator shaft) only by KONE maintenance users according to KONE installation manuals. The product is not intended to be used by ordinary persons.

• KCEDZS shall only be used as part of elevator.
• Only KONE maintenance users have access to the device.
• KCEDZS shall only be used with the provided cabling.
• KCEDZS shall only be used with internal antenna.
• KCEDZS shall be supplied with PELV/SELV voltage from another KONE device.
• KCEDZS is not to be connected to DC mains power distribution systems, but only to a dedicated DC power source.
• KCEDZS shall be installed by instructed person only (KONE maintenance users).
• KCEDZS shall be installed in a restricted access area.

KONE installation instructions for KCEDZS:

• AM-01.01.788 Installation instruction: Machine-room-less elevators installation
• AM-01.01.277 Installation instruction: Kone Monospace 300 and Kone Monospace 500
• SO-10.65.006 KCE Elevator car positioning system

The KCEDZS is automatically controlled by KONE KCE control system. It has following status indicators for maintenance user.

FCC/IC REGULATORY NOTICE

Modification Statement
KONE Corporation has not approved any changes or modifications to this device by the user. Any changes or modifications could void the user’s authority to operate the equipment.

Interference Statement
This device complies with Part 15 of the FCC Rules and Industry Canada licence-exempt RSS standard(s).

FCC Rules

Operation is subject to following two conditions:
(1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

Radiation Exposure Statement
This device complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines in Supplement C to OET65 and RSS-102 of the IC radio frequency (RF) Exposure rules. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

FCC Class B Digital Device Notice

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

CAN ICES-3 (B) / NMB-3 (B)
This Class B digital apparatus complies with Canadian ICES-003.

RF exposure safety
To comply with the measured SAR value/SAR testing exclusion, the equipment must be installed and operated with a minimum distance of 200 mm of the human body.

5 2014/53/EU DIRECTIVE REGULATORY NOTICE

This device is in conformity with the essential requirements of the 2014/53/EU Directive.

Hereby, KONE Corporation declares that the radio equipment type KCEDZS is in compliance with Directive 2014/53/EU.

The full text of the EU declaration of conformity is available at the following internet address: http://support.kone.com

In order to satisfy the essential requirements of 2014/53/EU Directive, the product is compliant with the following standards:

12015:2014EN 12016:2013
Health & Safety(RED art. 3.1a)| EN 62368-1:2014 + AC:2015 + A11:2017EN 62311:2008
RoHS (2011/65/EU)| Directive 2011/65/EU

There is no restrictions on putting into service or of requirements for authorisation of use within a Member State of the European Union

References

• KONE - Improving the Flow of Urban Life

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>