UTEC WG233E Wifi Module User Manual
- June 11, 2024
- UTEC
Table of Contents
WG233E Wifi Module
User Manual
Wi-Fi Module
The module WG233E is manufactured by SkyLab M&C Technology Co. The module is
capable of operating in IEEE 802.11a/b/g/n/ac and can operate in both the
2.4GHz and 5.8GHz band. The module operates in 2T2R mode and supports 2
external antenna connection points through two IPEX connectors. To prevent
unwanted emission noise, the radio IC is encapsulated with a with a metalized
EMI shield.
The wifi radio IC consists of a Realtek RTL8812 chipset. The interface between
the module and the microprocessor is USB 2.0 running at high speed and
operates off of 3.3V. Refer to the pinout of the module below.
Component| Model number| Specification| Manufacturer|
FCC ID
---|---|---|---|---
RF module/chip| WG233EC| IEEE802.11 a/b/g/n/ac 2.4G&5G WLAN dual antenna|
SKYLABS| 2ACOEWG233
Antenna 1&2| SKA15 220
Note: Sky labs internal model number is MST- 24/58BC-7| MAGNETIC DUEL
BAND
ANTENNA/SUCKER TYPE| SKYLABS| Not Applicable
Cable| SKA113 75| 75mm SMA/IPEX CABLE, ROHS COMPLIANT| SKYLABS| Not Applicable
Table 1 RF Component details
Skylab Module FCC Details:
Original Company Name: Skylab M&C Technology co., ltd
Original Model: WG233
Original FCC ID: 2ACOE-WG233
The original granted date is: May 27, 2020
Skylab Module ISED Details:
Original Company Name: Skylab M&C Technology co., ltd
Original IC: 20742-WG233
Original Marketing Name (PMN): WIFI MODULE
Original Model (HVIN):WG233
Original Firmware (FVIN): V1.0
UTEC, Inc. intend to market the product with new identification. The new
identification is placed on the Skylab’s Module.
New Company Name: UTEC, Inc.
New Model: WG233
New FCC ID: 2AK6N-WG233
New ISED ID: 703A-WG233
This device complies with part 15 of the FCC rules and with Innovation,
Science and Economic Development Canada’s licence-exempt RSS(s). Operation is
subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
FCC 15.21 statement:
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
End product labeling
This transmitter module is authorized only for use in device where the antenna
may be installed such that 20 cm may be maintained between the antenna and
users. The final
end product must be labeled in a visible area with the following: “Contains
FCC ID: 2AK6N-WG233” and Contains
IC: 703A-WG233.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>