PLEONIS PTH22FRWBUK 23 Inch Tower Heater User Manual
- June 6, 2024
- PLEONIS
Table of Contents
User Manual
23-Inch Tower Heater
MODEL: PTH22FRWBUK
The device is only suitable for well insulated spaces or occasional use.
SAFETY INSTRUCTION
-
Warning: In order to avoid overheating, do not cover the heater.
-
If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.
-
This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by children without supervision. -
The heater must not be located immediately below a socket-outlet.
-
Do not use this heater in the immediate surroundings of a bath, a shower or a swimming pool.
-
Children of less than 3 years should be kept away unless continuously supervised. Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been placed or installed in its intended mal operating position and they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the appliance or perform user maintenance.
-
CAUTION–Some parts of this product can become very hot and cause burns. Particular attention has to be given where children and vulnerable people are present.
-
Correct Disposal of this product This product complies with EU WEEE Directive and bears a classification symbol for waster electrical and electronic equipment (WEEE).
This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmental safe recycling. -
This heater cannot achieve accurate temperature control of the enviroment, and thus cannot be used as insulation device for storage environment, items, animals and plants.
-
Do not use this heater if it has been dropped.
-
Do not use if there are visible signs of damage to the heater.
-
Use this heater on a horizontal and stable surface.
-
WARNING: Do not use this heater in small rooms when they are occupied by persons not capable of leaving the room on their own, unless constant supervision is provided.
-
WARNING: To reduce the risk of fire, keep textiles, curtains, or any other flammable material a minimum distance of 1 m from the air outlet.
-
Details concerning precautions during user maintenance.
-
Consider all the information, including the information contained in the “CLEANING AND MAINTENANCE INSTRUCTION” chapter.
-
Household use only.
PART FIGURE
OPERATING INSTRUCTION
[Inspection before start]
- The power cord shall not be damaged or fractured.
- Please verify the rated current of the power socket is in line with the requirements in the table above and is equipped with a safety grounding device before use; otherwise, replace the socket.
[Start and power selection]
- Start The power light is lit after the plug is plugged in the power. The screen is off after a warning tone is heard and the screen is flickered once. The machine can be started after the switch key is pressed (or ON/OFF button on the remote controller is pressed).
- First use The machine will be operated under high gear working state by default when it is powered on for the first time. The screen displays “HI” and the Default setting temperature is 35°C.
[Function setting] Gear key is pressed repeatedly. the heater will be switched according to the circular order of “high gear–low gear–ECO energy saving gear–CO”. [Temperature setting]
- When the Heater in ECO mode , the temperature can be set by pressing “+” or “-“, with the setting range of 5-35°C.
- When the setting temperature is reached, the heater will stop the operation. When the temperature is lower than the set temperature, the machine will restart the heating.
[Timing function]
-
Timing stop
When the heater is turned on, press the TIMER key to enter the timing stop state (within 0-24 hours), then press the “+” key to increase the timing stop time , and press the “-” key to decrease the timing stop time. After the timed shutdown time is set, the timing can be canceled through long-press of the TIMER key. -
Timing start
When the electric heater is in the standby mode, press the TIMER key to enter the reservation start mode (within 0-24 hours), then press the “+” key to increase the reservation start time, and press the “-” key to decrease the reservation start time. Long-Press TIMER key to cancel the timer. After the timed startup time is set, the timing can be canceled through long-press of the TIMER key.
[Swing function] When the machine is under operating mode, “swing” button can be pressed to start swing function; such function can be closed after re- pressing of this button. After the machine stops heating function, the swing function will be stopped. [LED Display ON/OFF]
- When the heater is turned on and there is no operation in 60 seconds, the LED display will turn off. When LED display is off, press any button to wake up the display.
- When the heater is turned on, press and hold on “+” and “-” at the same time for 3 seconds to turn on the LED display permanently. Then press and hold on “+” and “-” at the same time for 3 seconds to turn off the LED display.
[Auto off function] After the machine is powered on and started, it will be
shut down forcibly in case of no valid operation after 12h continuous
operation with no timer.
[Short-circuit protection function of temperature sensor] In case the
temperature sensor has short circuit or open circuit, regardless of the mode,
the digital screen will display “E2” or “E1” and be illuminated, at this time,
the operation of any button is invalid, and the buzzer will be ringing for 10
times.
[Safety protection] When it is under startup state, and when the indoor
ambient temperature is higher than 50°C, the system will turn off all the
outputs, the digital screen will display “FF” and be flickered for 75 times at
a frequency of 1 time/second. At this time, pressing of any button will not
work, and the protection can only be withdrawn after the power is cut off.
[Tip-over protection] When the machine is tipped over, the screen will display
P4 and be shut down automatically and several warning tones will be sent. In
case the machine is aligned within 10 warning tones, the warning tone will be
stopped.
[Remote control] The remote control can be normally used within 5 meters in
front of the product and in the left and right angles of 30 degrees.
CLEANING AND MAINTENANCE INSTRUCTION
- The heater should be cleaned regularly to wipe out the dust on the surface of heater during the operating season in order to provide the optimum level of performance.
- Turn the heater “OFF”, unplug it and wait for the heater to cool down. Use a dry soft cloth to clean only external surfaces. Do not use any cleaning abrasives or detergents.
- Never immerse the heater in water.
- Store the heater in a cool and dry place.
- Do not scrap the surfaces of heater with sharp hard tools, to avoid surfaces getting rusty, because of damage of the paint coat.
TROUBLESHOOTING
If the product does not operate or does not operate properly, first check according to the following list. If the reason is not included in the following list, please contact the dealer.
| Problem | Possible Cause | Solution |
|---|---|---|
| After the power is engaged, the machine does not work. | ● The plug may not be | |
| plugged well. | Check whether the plug is properly inserted into the |
receptacle.
The machine suddenly stops during heating.| ● The temperature exceeds the
threshold of the thermal cut- off.| Pull off the plug manually and then insert
it into the receptacle again when the machine is cooled.
SERVICE AND SUPPORT
E-mail: cs_eu@pelonis.com
|
---|---
https://www.facebook.com/qr/106247481819056|
https://www.instagram.com/pelonis.uk?utm_source=qr
Table 2 for information requirements for electric local space heaters| P
---|---
Model identifier(s): PTH22FRWBUK
Item| I Symbol| I Value| I Unit| Item| I Unit
Heat output| Type of heat input, for electric storage local space heaters only
(select one)
Nominal heat output| Pnom| 2,0| kW| Manual heat charge control with integrated
thermostat| [no]
Minimum heat output (indicative)| Pmin| 1,2| kW| Manual heat charge control
with room and/or outdoor temperature feedback| [no]
Maximum
continuous heat output| Pmax| 2,0| kW| Electronic heat charge control with
room and/or outdoor temperature feedback| [no]
Auxiliary electricity consumption| Fan assisted heat output| [no]
At nominal heat output| elmax| N/A| kW| Type of heat output/room temperature
control (select one)
At minimum heat output| elmin| N/A| kW| Single stage heat output and no room
temperature control| [no]
In standby mode| elSB| 0,47| W| Two or more manual stages, no room temperature
control| [no]
| | | | With mechanic thermostat room temperature control| [no]
| | | | With electronic room temperature control| [yes]
| | | | Electronic room temperature control plus day timer| [no]
| | | | Electronic room temperature control plus week timer| [no]
| | | | Other control options (multiple selections| possible)
[no]
| | | | Room temperature control, with presence detection
| | | | Room temperature control, with open window detection| [no]
| | | | With distance control option| [no]
| | | | With adaptive start control| [no]
| | | | With working time limitation| [no]
Contact details:| Lifestyle Orchestra Co Pte. Ltd.
158 CELIL STREET#07-01-02 SINGAPORE (069545)
Company TC Kangbridge Ltd
Address: TC Lumionous house,300South row,Milton keynes,MK9 2FR
Tel/Mobile: +44(0)7908917780
E-mail: epr@tangcheng.top
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>