JL AUDIO SB-J-JK2DR/10W1v3 Stealthbox Installation Guide
- June 11, 2024
- JL AUDIO
Table of Contents
SB-J-JK2DR/10W1v3 Stealth box
Installation Guide
INSTALLATION GUIDE
for the SB-J-JK2DR/10W1v3
SKU# 94512 – 94513
2007 & Up Jeep Wrangler 2 Dr
SB-J-JK2DR/10W1v3 Stealth box
Thank you for choosing a JL Audio Stealth box® for your automotive sound
system. With proper installation, your new vehicle specific enclosed subwoofer
system will deliver years of listening pleasure.
We strongly recommend that you have your new Stealth box® installed by your
authorized JL Audio dealer. The installation professionals employed by your
dealer have the necessary tools and experience to disassemble and reassemble
your vehicle properly. Also, keep in mind that your warranty coverage extends
to 2 years if your system is installed or approved by your authorized JL Audio
dealer. If you prefer to perform your own installation, please read this
installation guide completely before beginning the process.
IMPORTANT
If you choose to perform the installation yourself, it is absolutely vital
that
the Stealth box® be properly mounted to the vehicle according to these
instructions. Failure to mount the enclosure properly presents two problems:
- The sub-bass performance will suffer due to the movement of the enclosure caused by the force exerted by the woofer(s).
- A loose enclosure presents a serious safety hazard in the event of a
collision or sudden deceleration.| INSTALLATION
DIFFICULTY:
1OUT
OF 5
ESTIMATED TIME:
1 HOUR
---|---
STEP 1
Empty out the cargo area so that you have a clean area to work in.
STEP 2
Fold the rear seat forward, and remove the floor panel.
STEP 3
Position the floor panel clip as pictured to allow it to fit in the void in
the bottom of the Stealth box®. STEP 4
Apply a Velcro Strip to each Bracket as shown. Using a 1/4” – 20 x 1 Bolt, a
1/4” Lock Washer, and a 1/4” Flat Washer, attach each Bracket to the Stealth
box® as shown, and firmly tighten. STEP 5
Pictured is the Stealth box® with the Brackets mounted.
STEP 6
Attach speaker wire to the terminal cup on the back of the enclosure, and
route the wire as necessary. Slide the Stealth box® into the vehicle, allowing
the Brackets to slide under the factory floor mounting points, and the
enclosure to drop into the well.
STEP 7
CONGRATULATIONS!
You have completed the installation for this model!
Enjoy your new Stealthbox®!
Please refer to the Power Recommendation section for an amplifier
recommendation and basic set-up help.
INCLUDED HARDWARE
(2) Bracket (2) 1/4” Lock Washer (2) Velcro Strip
(2) 1/4” Flat Washer (2) 1/4” – 20 x 1 Bolt
SPECIFICATIONS
Enclosure Type: Acoustic Suspension (sealed)
Driver Type: 10W1v3-2
Nominal Impedance: 2 ohm
Continuous Power Handling: 300 watts
POWER RECOMMENDATION
JL Audio recommends high quality amplifiers such as the JL Audio XD300/1v2. The diagram below shows the recommended crossover settings for the XD300/1v2. If another amplifier is being used, please reference this illustration and use similar settings on that amplifier. All JL Audio amplifiers are very versatile audio components. Please consult the owner’s manual for even more detailed information about installing and tuning your amplifier.
CONNECTIONS
Using quality power, signal and speaker wire is essential in ensuring the
performance of your Stealth box®.
JL Audio recommends using an 8 AWG power kit such as the XD-PCS8-1B for your
Stealth box® amplifier, other kits are available should you be using more
than one amplifier. Signal wire such as the JL Audio Premium Audio
Interconnect Cables should be used that will provide signal for both channels
of the amplifier. JL Audio recommends using 12AWG speaker wire for subwoofers
such as our XC-BCS12-25.
MID/HIGH FREQUENCY DRIVER FITMENT
A variety of JL Audio coaxial and component systems will fit in the factory
speaker locations of you vehicle.
Front Speaker Size / Location: 6-1/2”- Dash
Fits JL Audio Models: TR650-CXi, TR650-CSi, C2-650x, C2-650, C3-650,
C5-650x, C5-650, & ZR650-CSi
Rear Speaker Size / Location: 6-1/2”- Sound Bar Fits JL Audio Models:
TR650-CXi, TR650-CSi, C2-650x, C2-650, C3-650, C5-650x, C5-650, &
ZR650-CSi
All specifications are subject to change without notice. “JL Audio®” and the JL Audio logo, “Stealth box” and the Stealth box logo are registered trademarks of JL Audio, Inc. “Ahead of the Curve” and its respective logo is a trademark of JL Audio, Inc.
JLA-SKU# 011322 09.20.2016 • Printed in USA • ©2016 JL Audio, Inc.
For more detailed information please visit us online at
www.jlaudio.com.
10369 NORTH COMMERCE PARKWAY
• MIRAMAR, FLORIDA
• 33025 • USA
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>