COSTWAY JZ10105 Metal Storage Shelf Instruction Manual

COSTWAY JZ10105 Metal Storage Shelf

Product Information

The product code for this shelving unit is JZ10105. The total weight capacity of the unit is 1300 kg / 2866 lbs when the weight is evenly distributed. The unit measures 195 cm / 77 inches in height, 100 cm / 39 inches in width, and 40 cm / 16 inches in depth. The gross weight (GW) and net weight (NW) of the product is 41.8 lbs and 39.6 lbs respectively. The size of the product is 44.113.49.8 inches. This product is made in Italy.

Product Usage Instructions

1. Read the assembly, use, and maintenance manual carefully before assembling the product. Keep the manual close to the shelving unit for future reference.
2. During assembly, use protective gloves to protect your hands (not included).
3. Fit the first shelf at a height no more than 10 cm/4 inches from the floor to ensure correct upright strength.
4. Set the remaining shelves to a near equal distance as possible with respect to the total height of the shelving unit. The shelving must be assembled vertically.
5. Arrange the load on the shelves so it is uniformly distributed, without exceeding the maximum indicated load. Carefully place the loads on the shelves. Do not allow them to drop suddenly. Only load the shelves manually.
6. Clean the shelf using protection gloves.
7. Periodically check the structure every 6 months.
8. Check to make sure the screw and bolts are firm.
9. Perform a visual check to make sure the shelves are level and the uprights are truly vertical.
10. Check the general condition of the structure. If any faults are found (damaged or deformed components, excessive oxidization, etc.) immediately replace the damaged.
11. This shelving unit must only be used for storing materials. All other uses are forbidden!

Assembly Solutions

Joint Assembly

To assemble

ASSEMBLY USE AND MAINTENANCE MANUAL

IMPORTANT

• READ THESE INSTRUCTIONS CAREFULLY BEFORE ASSEMBLY OF THE PRODUCT.
• THIS MANUAL MUST BE LOOKED AFTER AND KEPT CLOSE TO THE SELVING UNIT FOR SUBSEQUENT REFERENCE.

1. ASSEMBLY: DURING ASSEMBLY, USE PROTECTIVE GLOVES TO PROTECT YOUR HANDS (not included);
   • Fit the first shelf at a height no more than 10 cm/4” from the floor (this will ensure correct upright strength);
   • Set the remaining shelves to a near equal distance as possible with respect to the total height of the shelving unit.
   • The shelving must be assembled vertically.
2. WALL MOUNTING: Once the shelving unit has been assembled & before being used, it must be fastened to the wall using specific screw anchors (not supplied). If the wall is made of a particular type of material, always use adequate fastening systems (ask qualified technician for help). Wall fastening should be done using the holes in the uprights – at least 2 fixing points at about ¾ the height of the shelving unit.
3. LOAD: Arrange the load on the shelves so it is uniformly distributed, without exceeding the maximum indicated load. Carefully place the loads on the shelves. Do not allow them to drop suddenly. Only load the shelves manually.
4. MAINTENANCE
   • Clean the shelf using protection gloves.
   • Periodically check the structure (every 6 months).
   • Check to make sure the the screw and bolts are firm.
   • Perform a visual check to make sure the shelves are level and the uprights are truly vertical.
   • Check the general condition of the structure. If any faults are found (damaged or deformed components, excessive oxidizations, etc.) immediately replace the damaged.

IMPORTANT NOTICES!

• THIS SHELVING UNIT MUST ONLY BE USED FOR STORING MATERIALS. ALL OTHER USES ARE FORBIDDEN!

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>