Current CBT14 CBT Indoor Lighting Instructions
- June 11, 2024
- current
Table of Contents
Current CBT14 CBT Indoor Lighting
NOTE: Components shown in images are representative only and may vary based on the configuration ordered.
CAUTION
Read the instructions carefully and turn the electricity off at the main
circuit breaker panel before beginning installation.
WARNING
If any special control devices are used with this luminaire, follow the
instructions carefully to assure full compliance with NEC requirements. If
there are any questions, contact a qualified electrical contractor.
WARNING
This product must be installed in accordance with the applicable installation
code by a person familiar with the construction and operation of the product
and the hazards involved.
WARNING
This product contains chemicals known to the State of California to cause
cancer, birth defects, and/or other reproductive harm. Thoroughly wash hands
after installing, handling, cleaning, or otherwise touching this product.
RECESSED MOUNTING
STEP 1
Different lumen and correlated color temperature levels can be achieved by
setting the switch on the driver cover to different positions.
NOTE: LS35 and LS40 luminaires only have one (1) switch.
STEP 2
Raise unit into ceiling. Cross tees may need to be trimmed when fixtures are
installed in certain applications. For instance when installing a 2×4 recessed
troffer into a 2×2 ceiling grid the cross tees would need to be trimmed or a
zero clearance cross tee utilized.
STEP 3
Open access plate. Use knockouts to connect power using appropriately sized
electrical fittings. Make wiring connections.
STEP 4
Bend T-bar clips into position. Support the fixture to the building structure
by support wires (supplied by others) through the grid clip hole.
currentlighting.com/columbialighting
- 2022 HLI Solutions, Inc. All rights reserved. Information and specifications are subject to change without notice. All values are design or typical values when measured under laboratory conditions.