VIKING E-10-IP VoIP Door Entry Phone User Guide
- June 4, 2024
- VIKING
Table of Contents
VoIP Door Entry Phone
User Guide
QUICK START GUIDE
E-10-IP or
E-10-IP-EWP
VoIP Entry Phone
February 11, 2021
**** See Product Manual for complete installation and programming instructions.
Out-of-Box
Verify that you have received all of the parts listed
| X 1| E-10-IP or E-10-IP-EWP
---|---|---
| X 1| Torx T-10 Security Bit
| X 5| Gel-Filled Butt Connectors
| X 1| Faceplate Gasket
| X 4| 6-32 x 3/4” Flat Head Torx
| X 1| Flush Mount Back Box
| X 1| Wire Nut
Download the product manual
scan the QR code to pen and download the product manual
– OR –
https://www.vikingelectronics.com/wp-
content/uploads/documents/product_manual/E-10-20-30-32-IP.pdf
- Go to www.vikingelectronics.com and enter E-10-IP in the search box
- Click E-10-IP in the search results
- Click Product Manual to open and download the PDF
Download and install the programming software
- Go to www.vikingelectronics.com and enter E-10-IP in the search box
- Click E-10-IP in the search results
- Scroll down the page to Downloads, click IP Programming Software
- Install the programming software by saving or opening the file and then clicking on setup Viking IP Programming.exe
- Follow the prompts on your screen to complete the software installation
Power Source
Select PoE Switch or PoE Injector that meets the following requirements:
- IEEE 802.3af / 802.3at / 802.3bt compliant
- Capable of providing at least 4 Watts (class 1)
Note: CAT5e (or higher) cable recommended
Network Port Settings
- Make sure the port is not in trunk mode
- Make sure the port is capable of 100mbps full-duplex
- If Spanning Tree Protocol (STP) is enabled, enable Portfast and BDPU Guard Globally
Features Overview
Note: The gel-filled (water-tight) butt connectors are designed for
insulation displacement on 19-26 gauge wire with maximum insulation of 0.082
inches. Cut off stripped wire ends before terminating.
*Note: The front panel of the E-10-IP is mounted using security Torx
screws to help prevent intruders from removing the panel and accessing the
onboard door strike/gate control relays. For applications requiring additional
security, a Viking model RC-4A remote relay controller can be used. The relay
controller is mounted securely inside the building and connected to the same
LAN as the E-10-IP. For more information on the RC-4A Secure Relay Controller,
see DOD 582.
See the Product Manual for complete installation and programming instructions.
Questions? Call Viking Product Support:
715-386-8666
Due to the dynamic nature of the product design, the information contained in
this document is subject to change without notice. Viking Electronics, its
affiliates, and/or subsidiaries assume no responsibility for errors and
omissions contained in this information. Revisions of this document or new
editions of it may be issued to incorporate such changes.
E-10-IP Quick Start Guide
ZF303591 REV B
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>