ARROW PR-34041-HPSL Pressure Injectable One-Lumen PICC with 130 cm Wire Instruction Manual

June 4, 2024
Arrow

ARROW PR-34041-HPSL Pressure Injectable One-Lumen PICC with 130 cm Wire

ARROW PR-34041-HPSL Pressure Injectable One-Lumen PICC with 130 cm Wire
PRODUCT

INTRODUCTION

  • 1: Three Lumen Catheter: 6 Fr. (2.14 mm OD) x 40 cm, Pressure Injectable, Blue FlexTip®
  • 1 Peel-Away sheath: 6.5 r. x 4″(10 cm) Radiopaque over 6.5 Fr. Dilator
  • 1: Spring-Wire Guide: .018″ (0.46 mm) dia. x 17-3/4″ (45 cm) (Straight Soft Tip on Both Ends)
  • 1Spring-Wire Guide, Marked: .018 (0.46 mm) dia. x51-3/16″ (130 cm)(Straight Soft I ip on
  • One End-Straight Stiff Tip on Other)
  • 1: Introducer Needle: Echogenic 21 Ga. x 2-3/4″ (7 cm) TW
  • 1: Syringe: 5 mL Luer-Lock
  • 1: Skin Protectant Prep
  • 3 Dust Cap: Non-vented
  • 1: SecondSite TM Adjustable Hub: Fastener
  • Secondsite Adjustable Hub: Catheter Clamp
  • 1: Patient ID Card
  • 1: Chart Sticker
  • 1: Patient Information Booklet
  • 1: Checklist/CLIP Sheet
  • 1 Paper lape Measure
  • 1: Dressing: STATLOCK®1 Catheter Stabilization Device
  • A registered trademark of C. R. Bard, Inc.

OVERVIEW

Rx only

  • Warning: Read all package insert warnings, precautions, and instructions prior to use.
  • Failure to do so may result in severe patient injury or death.

California Prop. 65

  • WARNING: Cancer and Reproductive Harm.
    www.P65warnings.ca.gov

  • Not made with natural rubber latex.

  • Fluid path components are non-pyrogenic.

  • Contraindications: The Pressure Injectable PICC is contraindicated wherever there is the presence of device-related infections or the presence of previous or current thrombosis in the intended insertion vessel or catheter pathway. Clinical assessment of patient must be completed to ensure no contraindications exist.ARROW PR-34041-HPSL Pressure Injectable One-Lumen PICC with 130 cm Wire FIG 2ARROW PR-34041-HPSL Pressure Injectable One-Lumen PICC with 130 cm Wire FIG 3

  • Priming volumes are approximate and are done witnout accessories.

  • flow rate values are approximate and are determined using deionized water at 100 cm head height.

  • Pump flow rates are determined at maximum pump pressure of 10 psig and represent approximate flow capabilitiesS.

  • Pressure injection flow rates are determined at the injector pressure seting of 300 psi maximum using media of 11.8 centipoise viscosity, with 152 cm pressure tubing.

Arrow International LLC
Subsidiary of Teleflex Incorporated
3015 Carrington Mill Blvd.
Morrisville, NC 27560 USA
Teleflex
www.teleflex.comn
LBLO62920 RO0 (2021-10)

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Arrow User Manuals

Related Manuals