TownSteel ED8900NE Stile Escutcheon Lever Trim Instructions
- June 11, 2024
- TownSteel
Table of Contents
ED8900NE Stile Escutcheon Lever Trim
Instructions
ED8900NE Stile Escutcheon Lever Trim
INSTRUCTION FOR NARROW STILE ESCUTCHEON LEVER TRIM
(ANSI Function 08)| (ANSI Function 14)| (ANSI Function 02)|
---|---|---|---
| | |
Entrance – Key Locks/Unlocks Lever| Passage – No Cylinder Lever Always Active|
Dummy – With Dummy Cylinder| Storeroom – Key Unlocks Lever
NOTE: 03 & 08 function – Standard collar height fits 1-1″ Mortise
Cylinder only , other Mortise Cylinder height should use proper size collar.
Step 1. Trim shipped with lever in the neutral (non-handed)
position.
Step 2. Rotate lever to desired hand. Insert (2) lever handing hex screws
together before tighten. Tghten these (2) screws with hex wrench.
Step 3. Install (2) thru-bolts. Insert spindle base on door thickness and
fix set screw. Suitable for door thickness (45-60mm)
After setting, please ensure the (2) lever handing screws are tighten to avoid
lever operating problems.
Cylinder installation: (follow )
Standard collar height fits mortise cylinder. ****
2021.01 changed to CHN 21 Ver81011
I-34EL-21A-US-BLANK