PYLE PGTAMPL150 40 Watt Guitar Amplifier User Guide
- June 4, 2024
- Pyle
Table of Contents
PYLE PGTAMPL150 40 Watt Guitar Amplifier
IMPORTANT SAFETY INSTRUCTIONS
WARNING: Before going any further, make sure that your amplifier is compatible with your mains electricity supply.
- Ensure that the MAINS (power) switch is set to the OFF position.
- Connect the supplied mains (power) lead into the mains electricity supply.
- Ensure that the VOLUME controls are set to zero.
- Plug your guitar into an INPUT jack socket.
- Turn the front panel MAINS switch to the ON position.
- Turn the VOLUME up to your preferred level and your amplifier is ready to play.
Function
- INPUT: Input for your guitar. Use a good quality guitar cable (i.e. one that’s screened/shielded) to help prevent noise, interference and unwanted feedback.
- GAIN: This control sets the operating level of the pre-amp. Simply turn up the Gain control until the required amount of distortion is achieved.
- SELECT: Select the drive channel or normal channel.
- TREBLE: Increasing the Treble will make your sounds brighter and more cutting, turning it down will decrease your tone’s edge and make it sound softer as a result.
- MIDDLE: Adjusts the sound level of middle-frequency range.
- BASS: Adjusts the sound level of the low-frequency range.
- LENGTH: This equalization controls reverb length
- DEPTH: This equalization controls reverb depth
- VOLUME: This is the overall level control for the normal channel.
- LINE OUT: This is a 1/4″jack for hooking up external speakersto the amplifier.
- PHONE: This is a 1/4″3-conductor stereo headphone jack for plugging in head phones.
- POWER: The power switch turns your amplifier on and off.
IMPORTANT SAFETY INSTRUCTIONS
- Read all safety and operating instructions before using this product.
- All safety and operating instructions should be kept for future reference.
- Read and understand all warnings listed on the operating instructions.
- Follow all operating instructions to operate this product.
- This product should not be used near water, i.e. Bathtub, sink, swimming pool, wet basement, etc.
- Only use dry cloth to clean this product.
- Do not block any ventilation openings, It should not be placed flat against a wall or placed in a built-in enclosure that will impede the flow of cooling air.
- Do not install this product near any heat sources; such as,radiators, heat registers, stove or other apparatus (including heat producing amplifiers) that produce heat.
- Protect the power cord being walked on or pinched, particularly at Plugs, convenience receptacles and the point where they exit from the apparatus.
- Unplug this apparatus during lightning storms or when unused for long periods of time.
- Care should be taken so that objects do not fall and liquids are not spilled into the unit through the ventilation ports or any other openings.
- Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way; such as, powersupply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally or has been dropped.
- WARNING:
To reduce the risk of fire or electric shock,
do not expose this apparatus to rain or moisture.
Questions? Issues?
We are here to help!
Phone: (1) 718-535-1800 Email:
support@pyleusa.com
Read User Manual Online (PDF format)
Loading......