Dimplex DXMBCF Tower Fan Instruction Manual
- June 5, 2024
- Dimplex
Table of Contents
Dimplex DXMBCF Tower Fan
Important Safety Advice
IMPORTANT:
THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE
WARNING:
To avoid danger of suffocation please remove all packaging materials
particularly plastic and EPS and keep these away from vulnerable people,
children and babies.
DO NOT
use this appliance until the base is properly assembled and it is standing
upright supported on and by its base only. Do not use lying down or lynig at
and angle against anything. Only use the appliance on a stable and level
surface.
DO NOT COVER
or obstruct the air inlet and outlet openings in any way. NEVER immerse the
appliance in water or other liquids; never spray liquids on the appliance.
NEVER
operate the appliance if a cable or connector has been damaged, after the
appliance has malfunctioned or if the appliance was dropped or otherwise
damaged in any way.
IMPORTANT:
Electric appliance may only be repaired by qualified personal, improper work
can be a source of considerable danger for the users. If the mains lead of
this appliance is damaged, it must be replaced by the manufacturer or its
service agent or a similarly qualified person in order to avoid a hazard.
WARNING:
In order to avoid a hazard due to inadvertent resetting of the thermal cut-
out, this appliance must not be supplied through an external switching device,
such as a timer, or connected to a circuit that is regularly switched on and
off by the utility.This appliance can be used by children aged from 8 years
and above and persons with reduced physical, sensory or mental capabilities or
lack of experience or knowledge if they have been given supervision or
instruction concerning the use of the appliance in a safe way and understand
the hazards involved. Children shall not play with the appliance. Cleaning and
user maintenance shall not be made by children without supervision. WARNING:
To avoid the risk of accidental strangulation from the supply cord all
children and vulnerable people must be supervised when in the vicinity of the
product whether it is working or not.The socket outlet must be accesible at
all times to enable the mains plug to be disconnected as quickly as possible.
IMPORTANT:
Disconnect the appliance from mains power whenever it is not in use and before
moving or relocating it.
DO NOT
operate the appliance at any voltage other than that specified on the rating
label.
WARNING:
To avoid the risk of damage or a dangerous situation do not use this appliance
or position any part of it near to heat, open flame, cooking apliances or any
heating appliance.
DO NOT
place any heavy objects on the appliance or any object against the product
when operating.
DO NOT
use the appliance in an area where there are likely to be flammable or
explosive fumes or liquids.
IMPORTANT:
To unplug the appliance do not pull on the mains cable, grip the plug at the
wall and pull carefully.
IMPORTANT:
Should the appliance fail to operate please check the fuse in the plug is
intact and confirm that the circuit breaker/fuse at your distribution board is
operating before contracting the manufacturer or service agent.
IMPORTANT:
Only use the appliance inside (indoors) and only for the purpose it was
designed.
IMPORTANT:
Unplug the appliance before cleaning.
WARNING:
Keep batteries out of reach of children, dispose of used button batteries
immediately and safely.
WARNING:
The remote control for this unit contains a small battery. To avoid risk of
choking, keep the remote away from children and do not swallow the battery. If
the battery is swallowed seek medical advice at once.
DO NOT
pull, carry ot move the appliance using the power cable. This instruction
leaflet belongs to the appliance and must be kept in a safe place. If changing
owners, the leaflet must be surrendered to the new owner.
How to assemble the base
Carefully remove the split base and the tower fan from its packaging.Pass the power cord between the centre of the two halves split base and fit the two halves’ together by lining the overlap bosses on the bottom (with cable exit) with their sockets on the other half dropping into place and pressing together.Bring the assembled base up to the bottom of the tower and line up the small pillar on the top of the raised centre of the base with the matching hole in the base socket location of the tower fan, pull the cable through fully so it doesn’t interfere with them fitting together.Take the 4 large screws provided and pass them through the holes in the circular bosses (located around the central hub on the underside of the base) into the bottom of the tower, screw fix them firmly in place.Carefully fit the cable through the slot to the back side of the hub and then through the guide location channel at the outside of the circular base to exit level with the base through the channel at the back. The Mont Blanc Cooling fan is now ready to stand and operate.
THIS IS NOT A FAULT
If the fan speed varies randomly including stopping and starting
automatically you have selected either NATURAL or NIGHTIME Variable Blower
Mode which simulate different breezy conditions. To de-select this mode you
must press thebutton to change back to constant blowing mode, please refer to
section ‘d’ following on how to change modes. To run in constant speed mode
only use the button to select the speed you require, please refer to section
‘b’ following.
Operating Instructions
The LED display screen on the control panel of the product illuminates to display what function you have selected when the fan is operating.
-
Turning on/off the fan: Gently press “Standby” button on the soft touch button control panel or the wireless remote control.
-
Adjusting and Selecting Speed: 3 contant speeds can be selected by pressing the button either on the control panel or on the remote. Each time you press this button the speed will cycle from I to II to III and back to ‘I’ again.
-
Where “I” = Low Speed, “II” = Medium Speed and “III” = High Speed.
-
Oscillating function: The product oscillates in an arc from left to right and back again continuously thus circulating the air flow over a wider area. To start the tower fan oscillating simply press the oscillating button on the control panel for less than 2 seconds or the button on the remote and the symbol will light up on the control panel. Press this button a second time to stop the oscillating.
-
Variable Blower Function Selection: The product can be set to automatically vary the speed output to simulate different breezy conditions. It will normally run in constant blowing mode at whichever speed you selected (see “b.” above). To select a variable blower speed function you can simply press the button on the remote or press and hold the dual control button on the control panel for at least 2 seconds. There are two selections available:
-
The first mode activated will be the ‘natural breeze’ selection and the symbol will light up on the control panel. In this mode the fan speed will continuously and randomly vary between speed levels (including off) to simulate variable wind conditions.
-
Pressing the on the remote a second time or pressing and holding the dual control button on the control panel again for atleast 2 seconds activates
‘night time’ selection and the symbol will light up on the control panel. In this mode the fan speed varies automatically between speed levels (including off) at a less noticeable rate than the ‘natural breeze’ selection. -
Pressing the button a third time for more than 2 seconds will change it back to constant normal blowing mode.
- Runback Timer function: The product can be set to switch off automatically after running for one of the four user selectable runback periods i.e. 1 hr, 2 hr, 4 hr or 8 hr. To activate the runback function just simply press the timer button
- Press once and the timer is set to 1hr runback
- Press twice and the timer is set to 2hr runback
- Press 3 times and the timer is set to 4hrs runback
- Press 4 times and the timer is set to 8 hrs runback
- Press a 5th time and the timer function is switched off.
Remote Control
The remote control comes complete with a CR2025 3V battery fitted. To replace the battery simply remove the securing screw, unclip and remove the battery cover on the back and replace the battery, then carefully refit the cover on the back and replace the battery, then carefully refit the cover, snap into place and refit the securing screw.
Technical Specification
Specification Details – DXMBCF | Symbol | Value | Unit |
---|---|---|---|
Maximum Fan Flow Rate | F | 9.2 | m³/min |
Fan Power Input | P | 32.3 | W |
Service Value | SV | 0.3 | (m³/min)/W |
Standby Power Comsumption | PSB | 0.64 | W |
Fan Sound Power Level | LWA | 64 | dB(A) |
Maximum Air Velocity | c | 4.1 | meters/sec |
Rated Voltage | V | 220-240 | V |
Rated Frequency | Hz | 50 | Hz |
Measurement Standard for Service Value | IEC 60879:1986 |
Cleaning
WARNING ALWAYS DISCONNECT FROM THE POWER SUPPLY BEFORE CLEANING THE
APPLIANCE
The fan should be cleaned at least once every two months as dust may
accumulate on the grill cover which would effect performance. Do not use
detergents, abrasive cleaning products or polish of any kind on the appliance.
Wipe with a dry cloth to remove dust and a damp cloth (not wet) to clean off
stains. Be careful not to allow moisture into the appliance. Use a vaccum
cleaner to remove and fluff which does accumulate.
Recycling
For electrical poducts sold within the European Community.At the end of the electrical products useful life it should not be disposed of within household waste.Please recycle where facilites exist. Check with your Local Authority or retailer for recycling advice in your country.If you don’t intend to keep the packaging of this product for later use or storage, please dispose of it in an eco-friendly way, please dispose of it in your recycling bin or nearest recycling facility, thank you.
Guarantee
What does a Dimplex Guarantee cover?
Dimplex products deliver reliable service for normal, household use in
domestic settings. All Dimplex products are individually tested before leaving
the factory.If you are a consumer and you experience a problem with your
Dimplex product, which is found to be defective due to faulty materials or
workmanship within the Guarantee Period, this Dimplex Guarantee will cover
repair or – at the discretion of Dimplex –replacement with a functionally
equivalent Dimplex product.Your product is under guarantee for 1 year from the
date of purchase or the date of delivery of the product, if later. The 1 year
guarantee is extended for an additional 2 years when you register the product
with Dimplex, within 28 days of purchase. If you do not register the product
with Dimplex within 28 days, your product will remain guarranteed for 1 year
only. To validate your extended guarantee register with us online at:
http://register.dimplex.co.uk. N.B. Each qualifying product needs to be
registered with Dimplex individually. Please note that the extended guarantee
is only available in the UK and Ireland.The Dimplex Guarantee is conditional
upon you providing the original purchase receipt as proof of purchase. Please
therefore retain your receipt as proof of purchase. If you do experience a
problem with your Dimplex product please call the Helpline on +44 [0]344 879
3588 or visit https://
www.dimplex.co.uk/support. For ROI
please email serviceireland@glendimplex.com
or call +353(0)1 842 4833. We will need details of your Dimplex product and a
description of the fault which has occurred. Once we receive your information
and proof of purchase we will contact you to make the necessary arrangements.
If your Dimplex product is not covered by this Dimplex Guarantee there may be
a charge to repair your product. However, we will contact you for agreement to
any charges before any chargeable service is carried out.
What is not covered by a Dimplex Guarantee?
The Dimplex Guarantee does not cover any of the following: Any fault or damage
to your Dimplex product due to faulty materials or workmanship occurring
outside the Guarantee Period. Normal wear and tear including parts that might
wear out over time or consumables, such as filters.Any fault or damage
occurring to any pre-owned Dimplex product or to any other equipment or
property.Accidental damage to your Dimplex product or damage to your Dimplex
product from external sources (for example, transit, weather, electrical
outages or power surges). Fault or damage to your Dimplex product which is:
- Not due to faulty materials or workmanship or which is due to circumstances outside Dimplex’s control.
- Caused by use of your Dimplex product for anything other than normal domestic household purposes in the country where it was purchased.
- Caused by any misuse, abuse or negligent use of the Dimplex product, including but not limited to any failure to use it in accordance with the Operating Instructions supplied with the product.
- Caused by any failure to assemble, install clean and maintain your Dimplex product in accordance with the Operating Instructions supplied with the product unless this was carried out by Dimplex or its authorised dealers.
- Caused by repairs or alterations to your Dimplex product not carried out by Dimplex service personnel or its authorised dealer(s).
- Caused by use of any consumables or spare parts for your Dimplex product which are not Dimplex – specified.
Terms and Conditions
The Dimplex Guarantee is valid for 1 calendar year, plus 2 if registered, from
the date of purchase of your Dimplex product from a recognised retailer in the
country of purchase and use, or the date of delivery of the product if later,
always provided the original receipt has been retained and is produced as
proof of purchase.You must provide to Dimplex or its authorised agents on
request the original receipt as proof of purchase and – if required by Dimplex
– proof of delivery. If you are unable to provide this documentation, you will
be required to pay for any repair work required. Any repair work under the
Dimplex Guarantee will be carried out by Dimplex or its authorised dealer(s)
and any parts that are replaced will become the property of Dimplex. Any
repairs performed under the Dimplex Guarantee will not extend the Guarantee
Period.The Dimplex Guarantee does not entitle you to recovery of any indirect
or consequential loss or damage including but not limited to loss or damage to
any other property.The Dimplex Guarantee is in addition to your statutory
rights as a consumer and your statutory rights are not affected by this
Dimplex Guarantee.Contact Dimplex A brand of Glen Dimplex UK Limited, trading
as Dimplex Dimplex Heating & VentilationIf you have any questions about what
the Dimplex Guarantee covers and does not cover or how to claim under the
Dimplex Guarantee, please contact us:Glen Dimplex Heating & Ventilation,
Grange Drive, Hedge End, Southampton SO30 2DFTelephone: 0344 879 3588 Visit:
www.dimplex.co.uk
References
- Electric Heating & Air Treatment For The Home | Dimplex
- Electric Heating & Air Treatment For The Home | Dimplex | Dimplex
- Customer Support | Dimplex
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>